Antec Fusion Remote Black user manual Display/Volume Control and the Remote Control, Hda

Picture 1

106 4 2

9 7 5 3 1

Pin Assignment for Audio Ports (HDA and AC’97)

Pin	Signal Names	Pin	Signal Names
	(HDA)		(AC’97)
1	MIC2 L	1	MIC In
2	AGND	2	GND
3	MIC2 R	3	MIC Power
4	AVCC	4	NC
5	FRO-R	5	Line Out (R)
6	MIC2_JD	6	Line Out (R)
7	F_IO_SEN	7	NC
8	Key (no pin)	8	Key (no pin)
9	FRO-L	9	Line Out (L)
10	LINE2_JD	10	Line Out (L)

Locate the internal audio connectors from your motherboard or sound card. Consult your motherboard or sound card manual for the pin-out positions.

The Display/Volume Control and the Remote Control

Fusion Remote comes with a Liquid Crystal Display (LCD) Display. It has a built-in MCE-compatible IR receiver, and a volume control to work with your media center computer. It also comes with a remote control to work with MCE and iMEDIAN HD software.

1.Make sure the power supply is off and unplugged before installing any hardware.

2.There is a 24-pin power adapter comes with the case. Connect the adapter to the power supply 24-pin ATX power connector. Connect the 3-pin power cable from the display to the 3-pin connector on the 24-pin adapter.

3.The display comes with a 4-pin internal USB adapter (see picture 1) and a standard external USB connector. To connect the display, either:

a.Connect the external connector to a standard USB port, or

b.Check your motherboard USB header pin layout. Match the internal adapter

to your motherboard header. Plug the internal adapter

into the external connector and plug it in to your motherboard’s USB header.

4.Plug in your power supply and turn it on.

5.Boot your computer.

6.Insert the provided driver CD into your optical drive and install the included software.

7.Restart after the driver has been installed.

8.Software use and capabilities

a.Press the “go” button to launch iMEDIAN HD

b.See the diagram at the back of the manual for descriptions of the functions of the keys on the remote control.

4