Hyundai W220S manual 10/27

Page 14

-Selecting a suitable location

-Connecting the PC

•15 pin D-sub / DVI-D /

HDMI

W220S

Multi Function 2D/3D Wide Monitor

•Place the monitor at least 30cm from other electrical or heat-emitting equipment and allow at least 10cm on each side for ventilation.

•Place the monitor in a position where no light shines directly onto or is reflected on the screen.

•To reduce eye strain, avoid installing the display unit against a bright background such as a window.

•Position the monitor so that the top of the screen is no higher than eye level.

•Position the monitor directly in front of you at a comfortable reading distance (around 45 to 90cm)

! Before you start cabling your monitor, check that the power is off on all units. To avoid any possibility of electric shock, always connect your equipment to properly earthed outlets.

1.Insert the other 15-pin/DVI-D/HDMI signal cable connector into the 15-pin VGA/DVI-D connection on your computer and screw it down.

2.Plug the power cord connection to connection on the monitor.

3.Plug the other end of the power cord to your computer's main supply or to a 100V-240V earthed electrical outlet.

4.Turn on the monitor using the power switch and check that the power LED is on. If not, repeat steps 1,2,3 and 4 or refer to the Troubleshooting section of this guide.

10/27

Page 13 Page 15
Image 14
Page 13 Page 15
Contents User’s Guide Page Declaration of Conformity W220S Multi Function 2D/3D Wide Monitor Introduction Safety Information Hyundai IT CORP. W220SW220S Multi Function 2D/3D Wide Monitor Cleaning and Maintenance Fire / Accident Prevention 3D Monitor Setting Guide Handling InstructionsA for 3D Mode W220S Multi Function 2D/3D Wide Monitor 3D Mode Specification Installing Monitor10/27 11/27 Speaker 13/27 14/27 15/27 16/27 Adjusting the picture 18/27 19/27 20/27 21/27 22/27 Display power management Troubleshooting By following the suggestions below25/27 26/27 Specifications
Top Page Image Contents