Instructions for use

2Press the SELECT key to select TV.

Press the key until TV lights up in the selector

window.

If TV does not light up, check whether the batteries are properly inserted

(see ‘Inserting the batteries’).

3 Check whether all keys are working. For an overview of the keys and their functions see ‘3. Keys and functions’.

– If the TV responds as it should to all of the key commands the SRU 5040 is ready for use.

•If the device does not respond at all or not to all of the key commands, follow the instructions under

‘Setting the remote control’, or for online setup go to: www.philips.com/urc.

Setting the remote control

This is only necessary if your device does not respond to the SRU 5040.

If that is the case, the SRU 5040 does not recognize the brand and/or model of your device and you need to program the remote control to do so.

The example below (TV) instructs you how to do this.You can repeat the same steps for other devices (DVD player/recorder, video recorder, etc.) which you want to operate using the SRU 5040.

Automatically setting the remote control

The remote control will now automatically search for the right code for your device.

Example of TV:

1Make sure the TV is switched on and select a channel using the original

remote control or the keys on the TV (for example channel 1).

•If the device is a DVD player/recorder or video recorder, insert a disk or tape and start playback.

2Press the SELECT key to select TV.

Press the key until TV lights up in the selector

window.

3 Then keep keys 1 and 3 pressed simultaneously for five seconds until TV in the selector window flashes twice and then remains lit.

4Press and hold the Standby key of the SRU 5040.

English