Mitsubishi Electronics LCD1560M manual Troubleshooting, No picture

Page 17

Troubleshooting

No picture

The signal cable should be completely connected to the display card/computer.

The display card should be completely seated in its slot.

Check the Vacation Switch should be in the ON position.

Front Power Switch and computer power switch should be in the ON position.

Check to make sure that a supported mode has been selected on the display card or system being used. (Please consult display card or system manual to change graphics mode.)

Check the monitor and your display card with respect to compatibility and recom- mended settings.

Check the signal cable connector for bent or pushed-in pins.

Power Button does not respond

Unplug the power cord of the monitor from the AC outlet to turn off and reset the monitor.

Check the Vacation Switch on the right side of the monitor.

Image Persistence

Image persistence is when a residual or “ghost” image of a previous image remains visible on the screen. Unlike CRT monitors, LCD monitors’ image persistence is not permanent, but constant images being displayed for a long period of time should be avoided.

To alleviate image persistence, turn off the monitor for as long as the previous image was displayed. For example, if an image was on the monitor for one hour and a residual image remains, the monitor should be turned off for one hour to erase the image.

NOTE: As with all personal display devices, NEC-Mitsubishi Electronics Display recommends using a moving screen saver at regular intervals whenever the screen is idle or turning off the monitor when not in use.

Image is unstable, unfocused or swimming is apparent

Signal cable should be completely attached to the computer.

Use the OSM Image Adjust controls to focus and adjust display by

increasing or decreasing the FINE control. When the display mode is changed, the OSM Image Adjust settings may need to be re-adjusted.

Check the monitor and your display card with respect to compatibility and recommended signal timings.

If your text is garbled, change the video mode to non-interlace and use 60Hz refresh rate.

LED on monitor is not lit (no green or amber color can be seen)

Power Switch should be in the ON position and power cord should be connected.

Display image is not sized properly

Use the OSM Image Adjust controls to increase or decrease the H.SIZE.

Check to make sure that a supported mode has been selected on the display card or system being used. (Please consult display card or system manual to change graphics mode.)

15

Image 17
Contents MultiSync LCD1560MTM Index FCC Information Canadian Department of Communications Compliance StatementContents Quick Start Figure A.1 Figure E.1 Remove Monitor Stand for Mounting Cable Management setup for tilt and swivelTilt and swivel Specifications Brightness/Contrast Controls ControlsSound Tools AccuColor Control SystemsInformation Recommended Use Safety Precautions and MaintenanceErgonomics Monitor MultiSync LCD1560M Specifications SpecificationsFeatures No picture TroubleshootingNo Video References Limited Warranty Black Model TCO’95TCO’95 White Model TCO’99TCO’99 Declaration of the Manufacturer Informations FCC AvertissementLa boîte* de votre nouveau moniteur NEC MultiSync contient ContenuMise en marche rapide Figure B.1 Mise en marche rapide suiteFigure D.1 Enlever le support du moniteur pour le montage Incliner et pivoterFiche Technique Exit CommandesOutils Commandes suiteInformation Consignes de sécurité et d’entretien Usage recommandéErgonomie Usage recommandé suiteFiche technique Fonctions Pas dimage DépannagePas de vidéo Dépannage suiteRéférences Garantie limitée Exigences environnementales Pourquoi des ordinateurs «éco-étiquetés»?Qu’est-ce qu’implique l’éco-étiquetage? Plomb TCO’95 suiteCadmium MercureTCO’99 C’est une traduction de portion Anglaise de TCO’99 Doses élevées TCO’99 suiteDéclaration du fabricant Page Page Déclaration DE Conformité Declaration of Conformity