Mitsubishi Electronics LCD1560M manual Tilt and swivel, Cable Management setup for tilt and swivel

Quick Start –continued

Tilt and swivel	Figure TS.1
Grasp both sides of the monitor screen with	your

hands and adjust the tilt and swivel as desired (Figure TS.1).

Cable Management setup for tilt and swivel

Damage can occur to the connection cables if not setup properly while operating the tilt or swivel feature. Please follow these steps to insure the correct cable setup.

1. When setting up your connection cables, be sure to leave the
stopper and ferrite core above the cable cover (Figure TS.2).	Figure TS.2
2. Gently test the tilt/swivel function, insuring that there is
no tension pull of the cables.

Remove Monitor Stand for Mounting

To prepare the monitor for alternate mounting purposes:

1.Disconnect all cables.

2.Place monitor face down on a non-abrasive surface (Figure R.1).

3.Remove the hinge cover (Figure R.1).

Stopper

ferrite core

Cable cover

4.Remove the 4 screws connecting the monitor to the stand and lift off the stand assembly (Figure R.2).

The monitor is now ready for mounting in an alternate manner.

5.Connect the AC cord and signal cable to the back of the monitor (Figure R.3).

6.Reverse this process to reattach stand.

NOTE: Use only VESA-compatible alternative mounting method.

NOTE: Handle with care when removing monitor stand. When the monitor stand is removed, the USB capabilities be disable.

Push Push

Hinge cover

Push Push

Figure R.2

Non-abrasive surface Figure R.1

Figure R.3

6