Mitsubishi Electronics LT-52249, LT-40153 Setting Up TV Inputs, Channel Scan for Digital Channels

121. Basic Setup and Operation

Setting Up TV Inputs

Channel Scan for Digital Channels

If you skip this step, the TV cannot receive digital channels.

If using an antenna or direct cable service (no cable box), connect the incoming coaxial cable to the TV’s ANT input. Refer to page 21.

You must perform a channel scan to enable reception of all available high-definition and standard-definition digital channels. The channel scan will search for channels available locally and save them to memory.

Memorizing Channels with Channel Scan For the ANT input

To start channel memorization

1.Power on the TV.

2.Press MENU and open the Initial > Channel menu.

Start channel memorization from the Initial > Channel menu.

3.Press ENTER to enter the menu.

4.Select Ant Air if connected to an over-the-air antenna. Select Ant Cable for direct cable (service without a cable box).

5.Highlight Scan and press ENTER. Channel memorization may take up to 15 minutes to complete.

To stop channel memorization before completion, press CANCEL.

Use the Initial > Channel > Edit menu (page 48) for additional channel options, such as adding or deleting channels from memory.

Setting Up Other Inputs

1.Connect your devices to the TV, making note of which TV input jack is used for each device. See “TV Connections,” page 16, for recommendations.

2.Power on the devices to ensure detection.

3.Power on the TV.

The TV will display the New Device Found screen for each new connection it detects Learn more about Auto Input/Auto Output Sensing on the opposite page.

4.Select the device type if the device is not recog- nized automatically.

Sample New Device

Found screen.

5.153 and 249 Series. You can perform NetCom- mand IR “learning” after selecting the device type or at a later time when convenient. To perform now, highlight NetCommand and press ENTER. See “Initial NetCommand Setup,” page 57 or “Setting Up A/V Receiver Control,” page 62.

Important Note for NetCommand IR Users

153 and 249 Series. Be sure to select the correct device type here. Although you can change the device type later in the Inputs > Name menu, any “learned” NetCommand IR codes will be erased when you make the change.

6.Press BACK to close the New Device Found screen. The TV will then display the New Device Found screen for the next connection it finds.

Downloaded From TV-Manual.com Manuals