Setup Procedure
1. Determine the installation location
CAUTION: DO NOT ATTEMPT TO INSTALL THE LCD MONI- TOR BY YOURSELF.
Installing your LCD display must be done by a qualified technician. Contact your dealer for more information.
CAUTION: MOVING OR INSTALLING THE LCD MONITOR MUST BE DONE BY TWO OR MORE PEOPLE.
Failure to follow this caution may result in injury if the LCD monitor falls.
CAUTION: Do not mount or operate the display upside down, face up, or face down.
CAUTION: Portrait use is not guaranteed for this product.
CAUTION: Do not install the LCD monitor where it will be exposed to direct sunlight, as this will result in display defects.
CAUTION: This LCD has a temperature sensor and cooling fan. If the LCD becomes too hot, the cooling fan will turn on automatically. If the LCD becomes overheated and the cooling fan is running, the “Caution” menu will appear. If the “Caution” menu appears, discontinue use and allow the unit to cool. When the LCD monitor is used in an enclosure or with protection on LCD surface, please check the inside temperature of monitor by “HEAT STATUS” (See page 27). The temperature is too hot than normal condition, please set “cooling fan” to ON on SCREEN SAVER function (See page 24).
IMPORTANT: Lay the protective sheet, which was wrapped around the LCD monitor when it was packaged, beneath the LCD monitor so as not to scratch the panel.
2. Install the remote control batteries
The remote control is powered by 1.5V AAA batteries. To install or replace batteries:
1.Press and slide to open the cover.
2.Align the batteries according to the (+) and
3.Replace the cover.
3.Connect external equipment (See page
•To protect the connected equipment, turn off the main power before making connections.
•Refer to your equipment user manual.
4. Connect the supplied power cord
•The power outlet socket should be installated as near to the equipment as possible, and should be easily accessible.
•Fully insert the prongs into the power outlet socket. Loose
connection may cause noise.
NOTE: Please refer to “Safety Precautions, Maintenance & Recommended Use” section of this manual for proper selection of AC power cord.
Cable Holder
5.Switch on the power of all the attached external equipment
When connected with a computer, switch on the power of the
computer first.
| 6. Operate the attached external equipment | |
| Display the signal on the external equipment you wish. | |
| 7. Adjust the sound | |
CAUTION | Make adjustments when adjustment of the volume is required. | |
| ||
Incorrect use of batteries can result in leaks or bursting. | 8. Adjust the screen (See pages | |
Be careful especially about the following points. | ||
• Place "AAA" batteries matching the + and - signs on each | Make adjustments when adjustment of the screen display | |
battery to the + and - signs of the battery compartment. | position or distortion is required. | |
• Do not mix battery types. |
| |
• Do not combine new batteries with used ones. It causes | 9. Adjust the image (See page | |
shorter battery life or leakage of batteries. | ||
Make adjustments when adjustment such as the brightness or | ||
• Remove dead batteries immediately to prevent battery liquid | ||
contrast is required. | ||
from leaking into the battery compartment. Don't touch ex- | ||
10. Recommended Adjustment | ||
posed battery acid, it cause damage to your skin. | ||
NOTE: If you do not intend to use the Remote Control for a long |
| |
period, remove the batteries. |
|