Mitsubishi Electronics LDT37IV, LDT32IV Upright position Lay the screen face down, English-12

Page 15

How to Mount and Attach Options to the LCD Monitor

You can attach mounting accessories to the LCD monitor in

one of the following two ways:

1. In the upright position

2. Lay the screen face down

Protective Sheet

Table

Tabletop Stand

Lay the protective sheet on a table, which was wrapped around the monitor when it was packaged, beneath the screen surface so as not to scratch the screen face.

This device cannot be used or installed without the Tabletop Stand or other mounting accessory. Failure to follow correct mounting procedures could result in damage to the equipment or injury to the user or installer. Product warranty does not cover damage caused by improper installation.

Failure to follow these recommendations could result in voiding your warranty.

When using with other mounting accessory, it must be a VESA- compatible mounting method and the screws must be M6 of size and 10mm or longer of length under consideration of the thick- ness of the mounting method. (Recommended torque: 470 - 635N•cm). MITSUBISHI ELECTRIC recommends using mount- ing interface that comply with TÜV-GS and/or UL1678 standard in North America.

3.Ventilation Requirements for enclosure mounting

To allow heat to disperse, leave space between surround- ing objects as shown in the diagram below.

4. To avoid falling down

Fasten the LCD monitor to wall using a cord or chain, which is sufficient to support the weight of the LCD monitor (LDT321V: approx. 17.5kg / LDT371V: approx. 22kg).

See diagram below.

Screw Holes

Cord or Chain

ClamperScrew

LDT321V: 360mm

LDT371V: 462mm

Before moving the LCD monitor, the cord or chain should be removed.

English-12

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Page Page English Deutsch Español Français Italiano Nederlands English-1 IndexEnglish-2 Important InformationCanadian Department of Communications Compliance Statement FCC InformationDeclaration Declaration of the ManufacturerEnglish-3 Recommended Use ErgonomicsEnglish-4 Contents English-6 Switches the power on/off. See alsoActs as Exit button to move to previous menu with OSD MenuEnglish-7 Terminal PanelEnglish-8 Wireless Remote ControlEnglish-9 Setup Procedure How to remove the stand Installing and removing standTo prevent the main power switch From being changed How to install standUpright position Lay the screen face down Ventilation Requirements for enclosure mountingEnglish-12 English-13 Wiring DiagramConnections Before making connectionsEnglish-14 Connecting a Personal ComputerConnecting with Digital Interface Equipment Connect the LCD Monitor to a Computer with a Digital OutputEnglish-15 Connecting a DVD Player with component out Connect the LCD Monitor to a DVD PlayerEnglish-16 English-17 Using the remote control Power on and OFF ModesPressing the Main Power Switch Pressing the power buttonEnglish-19 Power IndicatorPower IndicatorOSD On-Screen-Display Controls Color Picture ResetClock Phase TintAudio Reset Zoom ModeResolution Screen ResetAuto Adjust PIP Size PIP Audio PIP ResetConfiguration Auto SetupColor System ResetFactory Reset Screen SaverOSD H Position OFF TimerOSD Turn OFF Information OSDAdvanced Option Input ResolutionScan Mode Film ModeImage Sticking of LCD Panel English-28 RecommendationsEnglish-29 Controlling the LCD monitor via RS-232C Remote ControlEnglish-30 Power onEnglish-31 FeaturesTroubleshooting English-33 SpecificationsEnglish-34 Specifications LDT371V BJ544English-35 Pin AssignmentMitsubishi Contact Information
Top Page Image Contents