Planar E2c Display manual Install the Display Controller, To install the display controller

Page 16

Install the Display Controller

Before you install the AX1 display controller, make sure your display system will be set up in a well-ventilated location with an adequate amount of space. Excessive heat cannot dissipate when display vents are blocked.

Turn off your computer and peripherals. Disconnect all the cables. Leave the power cord plugged into the grounded outlet.

If you are installing multiple display controllers, install all boards before you install the display driver.

To install the display controller

1Remove the computer cover and then the blank bracket from the available PCI Express slot.

2Insert the display controller into the slot, align the connector pins, and press the board down until it is firmly seated.

3Secure the mounting bracket, and reattach the computer cover and the peripherals.

Note

Diagnosis requiring DICOM calibration with the Dome CXtra software can only be supported on the DVI-D interface.

6 Dome E2c Display

Image 16

Contents Dome E2c Display User’s GuidePlanar Systems, Inc. All rights reserved Contents Product Information Symbol explanations Intended useSafety precautions Safety tipsUnpacking and handling tips Preventing fire and injuryCleaning the display Shipping/storing the display Disposal informationQuick reference About the Display System RequirementsDisplay Components Display Positions Tilt range Height rangeDesk Stand Features Stand cable coverInstalling the Display TipsInstall the Display Controller To install the display controllerConnect the Video and Power Cables To connect the cablesTo install the driver Install the Display DriverTo configure the display Adjust Display Properties To use a dual-display configurationTo set the display orientation To set brightnessAppendix Troubleshooting Problem Possible Cause SolutionDome E2c Specification Category Characteristic Item SpecificationReliability Power SupplyEnvironment Video Modes Video TimingConnector Ports Reset left and LED on connector plate LED Indication LightsDisplay Driver Removal To remove the AX1 driverPower Management Index Brightness, displayRegulatory Compliance Canada, European Union, United StatesFax + 358 9 420 EU Declaration of Conformity for Medical Application FCC Compliance Statement Australian ChinaJapan KoreaStandard Warranty Return Procedure Standard WarrantySummary Summary Limitations and Exclusions of Dome Displays Limitation of Implied WarrantiesExclusion of Damages Effect of Local LawMedicalsales@planar.com Medicalsupport@planar.com