Mitsubishi Electronics WS-65908, WS-55908 manual Advanced Menu Convergence

Part III: Setup

Advanced Menu: Convergence

Convergence

(Figure 1)

Your Mitsubishi TV has three picture tubes which are aligned to properly converge the projected light beams on the screen. Each picture tube projects a single color of red, blue or green. During production, your TV was carefully adjusted to properly align these colors. As a special feature, you have the ability to adjust the red and blue light beams in reference to the xed gr een l ight beam. This process is called convergence.

Figure 1. Convergence selection in the Advanced menu

Convergence

Convergence Menu

(Figure 2)

Convergence aligns the entire screen at once. Select either Red Convergence or Blue Convergence to begin alignment. To align 64 individual points, see Advanced Convergence, page 41.

Reset Factory Defaults

(Figure 2)

This allows you to reset the convergence to the factory settings. The message “Conver- gence completed” will be displayed when the factory defaults have been restored.

Convergence Screen

(Figure 3)

When the Red and Blue crosshairs are prop- erly converged, the center-screen crosshairs will appear white. You can use , , ,

or to move the Red and Blue crosshairs. Press VIDEO to switch between Red and Blue. Press AUDIO for the Advanced Con- vergence screen, and see Advanced Conver- gence, page 41, for instructions.

Figure 2. Convergence menu

Red

Press ADJUST to converge the lines

Press VIDEO to switch to Blue

Press MENU to go back

Press CANCEL to delete changes

Press AUDIO Advanced Convergence

Figure 3. Convergence screen

40