Mitsubishi Electronics WS-55908, WS-65908 manual Programming, Products

Part III: Setup

Programming the Remote Control: To Control Other A/V Products

CABLE/DBS/DTV VCR DVD		POWER
TV	AUDIO
1		2

3DVD/LDP Player Codes

DVD/LDP brand	Code to enter:	If your
Mitsubishi (DVD)	003	DVD
Mitsubishi (LDP)	016, 017	code is not
		listed here,
Panasonic	250
		please see
Pioneer DVD (LDP)	252 (016, 017)
		page 62
Sony	254
		for a
Toshiba	253
		complete
To reset to default code, enter 000		listing.

Figure 4. Programming the remote to control your DVD/ LDP.

After entering the correct codes in each posi- tion of the remote control, use the slide switch to select which product will respond when an operational button is pressed. If you enter a code from the AUDIO chart while the slide switch is set to TV, the volume and mute functions change to match the A/V receiver. This is useful when using an A/V receiver with the TV all the time.

In all other cases, only one of the below devices is allowed for each slide switch posi- tion.

TV position:

TV

A/V receiver (volume and mute only)

Programming the

CABLE/DBS/DTV VCR DVD		POWER
TV	AUDIO
1		2

3A/V Receiver Codes

Audio brand	Code to enter:	If your
Mitsubishi A/V receiver	Set M-VR1000 or M-VR800 to 015	audio
and/or CD player	Set M-VR900 or M-VR700 to 010	code is not
		listed here,
Denon	234, 235, 236
		please see
Kenwood	200, 208
		page 62
JVC	232, 233
		for a
Onkyo	209, 214
		complete
Pioneer	205, 207
		listing.
Sony	222
Yamaha	201, 202

To reset to default code, enter 000

Figure 5. Programming the remote to control your A/V receiver.

Cable/DBS/DTV position:

Cable box

Satellite receiver

DTV receiver

VCR position:

VCR

DVD position:

DVD

LD Player

Audio position:

A/V receiver

Mitsubishi CD player [If you have a Mitsubishi A/V receiver, the audio position may be used in conjunction with select Mitsubishi CD players. Your audio position must be programmed to either 010 or 011. Plug the CD player power cord into a switched outlet on the back of your A/V receiver. Pressing the POWER button will then turn on your A/V receiver, in turn, turning on your CD player. On select CD players, the transport controls (FF, Play, Rew, etc.) in the audio position will operate the CD player.]

Remote Control: To Control Other A/V

If the slide switch is set to TV when you enter an A/V receiver code, VOLUME and MUTE will control the A/V receiver rather than the TV. To return volume and mute control to the TV, set the slide switch to TV, press and hold POWER and enter 000.

Some manufacturers may change their products, or they may use more than one remote control system. If this is the case, your remote control may not be able to operate your VCR, DVD, cable box, satellite receiver, or A/V receiver.

Products

27