BEFORE OPERATIONS: CONNECTIONS
2. CONTROL JACK CONNECTIONS
Use a commercially available
By connecting the optional
AFader starting by DJM-300
When using two players in tandem, connect the CON- TROL jacks of the two players. This makes it possible to achieve automatic alternate operation of the two play- ers. For details, see p. 12.
NOTE:
Fader start and relay play cannot be performed simultane- ously, since different control cable connections are required.
Use a commercially available mini- plug (dia. 3.5 mm; either stereo or monaural can be used) cable to con- nect the CONTROL jacks.
The fader starting or back cuing of this unit can be controlled from the DJ mixer.
|
|
|
|
|
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
B Fader starting by |
|
| Use a commercially available mini- |
| plug (dia. 3.5 mm; either stereo or |
| monaural can be used) cable to con- |
| nect the CONTROL jacks. |
| The fader starting or back cuing of |
| this unit can be controlled from the |
| DJ mixer. |
|
CRelay play using two players
This makes it possible to achieve automatic alternate operation of the two players.
Use a commercially available mini- plug (dia. 3.5 mm; either stereo or monaural can be used) cable to con- nect the CONTROL jacks..
3. POWER CORD CONNECTIONS
After all other connections are made, connect the power cord to a household wall outlet or to the auxiliary AC power takeoff on your amplifier.
ÖMake sure plugs are fully inserted into the jacks and
wall outlet.
NOTE:
If you do the following actions when the disc is spinning in the unit, the unit may malfunction.
1)Set the power switch to off, then on.
2)Disconnect the power cord, then connect again. To correct, press the EJECT button to stop the disc. You may then resume player operation.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the power cord once in a while. When you find it damaged, ask your nearest PIONEER authorized service center or your dealer for a replacement.
6
<DRB1232>
En
