To install batteries in the remote control unit

Getting started

To connect the power cord

When all the audio/video connections have been made, insert the smaller plug of the supplied AC power cord to the unit’s AC IN connector, then insert the other end to the wall outlet. Make sure that plugs are inserted firmly. The STANDBY indicator lights and setup is completed.

Warning

•Disconnect the power cord if you are not going to use the unit for a long time.

•Disconnect the power cord before cleaning the unit.

•Disconnect the power cord before moving the unit.

•Do not connect or disconnect the power cord with wet hands.

•Do not pull the power cord when disconnecting it, as this may damage the cord and cause fire, electric shock, or other accidents.

Warning

•Do not damage, alter, twist, or pull the power cord, as this may cause fire, electric shock, or other accidents.

•To prevent any accidents or damages caused by an unsuitable AC power cord, only use the supplied power cord. If the cord is damaged, contact a dealer and get the new power cord.

•Do not put anything heavy, or the unit, on the power cord, as this may cause fire, electric shock, or other accidents.

To install batteries in the remote control unit

The battery compartment is located on the back of the remote control unit.

1Press down on the point shown by the arrow at the top of the compartment cover,

and pull up the cover to open the compartment.

2 Place the two accessory R6P (SUM-3)/AA(15F) batteries in the remote control according to the polarity markings (“+” and “–”) inside the compartment and on the batteries.

3Place the cover over the compartment, and press down lightly.

•The batteries will last about six months with normal use. If the functions of the remote control become erratic, replace the batteries. See below for more information.

Precautions for the safe use of batteries

Observe the following precautions for the safe use of batteries. If they are used improperly their life will be shortened, they may burst or their contents may leak.

Precautions

•Remove the batteries from the remote control if it is not going to be used for a long period of time.

•Remove dead batteries and dispose of them properly.

•Never leave dead batteries lying around, take them apart, mix them with other refuse, or throw them into an incinerator.

•Never touch liquid that has leaked out of a battery.

•Do not mix new and old batteries, or batteries of different types, when replacing them.