JVC LT-32X585, T-26X585, LT-26X575, LT-32X575 manual Connecting to a Digital TV Receiver

Quick Setup Connections

Connecting to a Digital TV Receiver

By connecting a Digital TV Receiver, high definition pictures can be displayed on your TV in their digital form.

75Ω (UHF/VHF)

	INPUT
	R -
	AUDIO - L
	TV Rear Panel
DTV Decoder	VIDEO
	3
	INPUT
	R -
	AUDIO - L

TV Rear Panel

-IN DIGITAL

DIGITAL OUT AUDIO OUT

L R

COMPONENT1	Pr				Y
INPUT					Pb
AUDIO	R	-	AUDIO	-	L
DIGITAL IN
OUT	R				L
AUDIO

HDMI to DVI Cable

After the connections have been made, tighten the screw to secure the cables.

1)Connect the HDMI to DVI Cable from the DIGITAL OUT on the back of your DTV decoder, to the DIGITAL-IN on the back of your television.

2)Connect a red cable from the DTV decoder RIGHT AUDIO OUT, to the RIGHT AUDIO DIGITAL-IN on the back of your television.

3)Connect a white cable from the DTV decoder LEFT AUDIO OUT, to the LEFT AUDIO DIGITAL-IN on the back of your television.

•The digital-in terminal is not compatible with the picture signal of a personal computer.

•Use a HDMI to DVI cable (commercially available) in order to digitally connect the television with a DTV decoder.

Notes:

•If 480p signals (640x480 or 720x480) are displayed on the screen, the horizontal balance may be slightly shifted. Access the “DIGITAL-IN” in the initial setup menu to adjust it. (Refer to page 45.)

•When you do the above connection, set DIGITAL-IN AUDIO in the Initial Setup menu to ANALOG. See "DIGITAL-IN AUDIO", page 45.

19