Troubleshooting

If your TV fails to work properly, check the following guidelines for possible causes and solutions. Consult your local dealer or service outlet if problems persist.

Problem		Solution
No power.	t	Make sure the power cord is plugged in.
	t The power is o, press the Power button to turn on the TV.
	t	Try another outlet.
	t Unplug the unit for an hour, then plug it back in.
Poor sound or no sound.	t	Press the VOL button on the remote control or the VOL +
		button on the TV.
	t Press MUTE on the remote control to ensure that mute is not on.
	t The channel or cable TV is experiencing problems, tune to
		another channel.
	t Check the TV audio settings.
	t Check for possible sources of interference.
Poor picture or no picture.	t	The channel or cable TV is experiencing problems, tune to
		another channel.
	t Make sure that channels are set into memory.
	t Check the antenna or cable TV connections.
	t Check for possible sources of interference.
Poor reception on some	t	The channel or cable TV is experiencing problems, tune to
channels.		another channel.
	t Make sure that channels are set into memory.
	t The network signal is weak, adjust the antenna to receive better
		reception.
	t Check for possible sources of interference.
The remote control does	t	Batteries may be weak, dead, or inserted incorrectly.
not work.	t	Point the remote control directly at the remote sensor on the TV
	t
		with an angle of 35º.
	t Remove any obstacles between the remote control and the TV.
	t Remote control is out of range, move closer to the TV.
TV shuts o.	t	Sleep timer is set.
	t	Power is interrupted.
No CATV reception.	t	Check all cable TV connections.
	t Set the TV Mode in Channel menu.
Closed caption is not	t	The program tuned is not closed captioned. Try another channel.
activated.	t	Enable Closed Caption in the menu.
	t	Enable Closed Caption in the menu.