JVC PD-42X776 manual Connecting to JVC AV Compu Link, AV CompuLink Cable

Quick Setup Connections

Connecting to JVC AV Compu Link

JVC’s AV CompuLink feature makes playing video tapes or DVDs totally automatic. Simply insert a pre-recorded tape into your JVC brand VCR or DVD into your JVC DVD player and the device will automatically turn on and begin playback. At the same time, using the

AV CompuLink, the VCR or DVD player sends a signal to the television telling it to turn on and switch to the proper video input.

•The AV CompuLink cable may be included with the JVC AV CompuLink unit you wish to connect. If it is not, contact JVC Parts Department at (800)-882-2345, or www.jvcservice.com for part # EWP 805-012.

•AV CompuLink can only be used with JVC brand products.

AV CompuLink Cable

To Connect: Plug one end of the AV compu link cable into the AV COMPU LINK INPUT on your VCR, DVD, or other compu link device. Plug the other end of the AV compu link cable into the AV COMPU LINK at the rear of the TV.

Note:

•The AV compu link cable has a male 3.5 mm (mono) plug on each end.

VIDEO AUDIO

DIGITAL DIGITAL

AV COMPULINK HDMI

IN

VCR

V L R

IN

OUT

OUT

TV Underneath Panel

AV CompuLink

Notes:

•In order for the VCR playback to begin automatically, the recording tabs must be removed from the VHS tape. If the tab is in place, automatic switching will occur when you push the VCR’s PLAY button.

•If your JVC brand VCR has “A code/B code remote control switching” (see your VCR’s instruction book), using VCR A code will switch the TV to input 1.

•Refer to your DVD instruction book for detailed connection information.

•To connect a JVC HiFi receiver or amplifier for a completely automated home theater, see the receiver connection instructions for detailed connection information.

•AV CompuLink is compatible with select AV CompuLink receivers.

18