JVC LT-32E488, LT-42E488, LT-37E478 Channel Guard Message, Set Lock Code screen will appear

Initial Setup

Set Lock Code

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes pre- set with a lock code of “0000”. You may change the code to any four-digit number you wish. To change the lock code, follow the steps below.

	Press the MENU button
π†	To "Initial Setup"
è	To enter
π†	To "Set Lock Code"
è	To operate (Password input screen will appear)
	Enter the password by using the 10 button
	keypad

Initial Setup > Set Lock Code

Lock Code			0	1	2	3
Set				Clear
OK		BACK				MENU
Select	Operate			Back			Exit

The Set Lock Code screen will appear

To set the password, use the 10 button keypad

Press the OK button to finish (your lock code is now set)

When a viewer attempts to watch a blocked channel, this message appears:

The channel will remain blocked until the correct lock code is entered (see above for information on setting your lock code).

This programming exceeds

your rating limits. Please enter lock code by 10 key pad to unlock it.

No. - - - -

Notes:

•After a power interruption you must reset the lock code.

•Write your lock code number down and keep it hidden from potential viewers.

•If you forget the lock code, a new code may be set using the steps listed above.

Channel Guard Message

When a viewer attempts to watch a guarded channel, the following message appears:

To watch a channel that you have locked, enter the Lock Code using the 10 key pad.

If the wrong code is entered, the message "Invalid Lock Code !” will appear on the screen.

The channel cannot be accessed until the correct code is entered.

Notes:

This channel is locked by channel guard.

Please enter lock code by 10 key pad to unlock it. No. - - - -

•Once a channel has been unlocked, it will remain unlocked until the television is turned off.

•See also “Set Lock Code”.

35