JVC LT-40FH97 manual Connecting to a Digital TV Receiver

Quick Setup

Connecting to a Digital TV Receiver

By connecting a Digital TV Receiver, high definition pictures can be displayed on your TV in their digital form.

TV Rear Panel

DTV Decoder

DIGITAL OUT AUDIO OUT

L R

TV Rear Panel

1		AUDIO INPUT
HDMI	R
		L
FOR
OUT	S-VIDEO
		VIDEO
REC

HDMI to DVI Cable

After the connections have been made, tighten the screw to secure the cables.

1)Connect the HDMI to DVI Cable from the DIGITAL OUT on the back of your DTV decoder, to the DIGITAL-IN on the back of your television.

2)Connect a red cable from the DTV decoder RIGHT AUDIO OUT, to the RIGHT AUDIO INPUT "FOR HDMI 1" on the back of your television.

3)Connect a white cable from the DTV decoder LEFT AUDIO OUT, to the LEFT AUDIO INPUT "FOR HDMI 1" on the back of your television.

•The digital-in terminal is not compatible with the picture signal of a personal computer.

•Use a HDMI to DVI cable (commercially available) in order to digitally connect the television with a DTV decoder.

Notes:

•If 480p signals (640x480 or 720x480) are displayed on the screen, the horizontal balance may be slightly shifted. Access the “DIGITAL-IN” in the initial setup menu to adjust it. (Refer to page 52.)

•When you do the above connection, set DIGITAL-IN1 AUDIO in the Initial Setup menu to ANALOG. See "DIGITAL-IN1 AUDIO", page 53.

•The Analog Audio input can only be used with the HDMI 1 input.

•When setting the “DIGITAL AUDIO – ANALOG / DIGITAL” menu setting on the TV, please note that this setting only effects the HDMI 1 jack and that if you use a DVI to HDMI adapter this connection must be made to the HDMI 1 along with analog audio cables.

19