Kramer Electronics user manual Connecting the TP-551 and TP-552, Adjusting the EQ. Level

Connecting the TP-551 and TP-552

5Connecting the TP-551 and TP-552

You can use the TP-551HDMI Line Transmitter with the TP-552HDMI Line Receiver to configure an HDMI transmitter/receiver system.

To connect the TP-551to the TP-552, as illustrated in the example in Figure 5, do the following:

1.Connect the CAT 5 OUT A and B RJ-45 connectors on the TP-551to the CAT 5 IN A and B RJ-45 connectors on the TP-552respectively, via two STP CAT 5e 24AWG cables (see section 5￿ .2).

2.On the TP-552, connect the HDMI OUT connector to an HDMI acceptor (for example, a plasma display).

3.Connect the 12V DC power adapter to the power socket and connect the adapter to the mains electricity on both1 the TP-551and the TP-552(not shown in Figure 5).

4.On the TP-551, set the OUTPUT GAIN2 to LOW or HIGH according to the length of the CAT5 cables.

5.On the TP-551, connect an HDMI source (for example, a DVD player) to the HDMI IN connector.

6.On the TP-552, adjust the equalization level (see section 5￿ .1).

5.1Adjusting the EQ. Level

To adjust the EQ. according to the cable length:

1.Press the EQ. SELECT button for about 3 seconds to enter the setup mode. The INPUT or OUTPUT LEDs blink3.

2.Keep the EQ. SELECT button pressed to cycle through the four equalization states, as defined in Table 3.

Table 3: Equalization Levels Setup

LED STATUS		Equalization Level Suitable for:
INPUT LED	OUTPUT LED
Blinking	Off	Short cable length
Blinking	On	Medium cable length
Off	Blinking	Long cable length
On	Blinking	Extra long cable length

1 The TP-551/TP-552 does not include the Kramer power connect feature 2 Set to LOW for short cables and to HIGH for long cables

3 According to their current setup

8 KRAMER: SIMPLE CREATIVE TECHNOLOGY