Operation
Remote Control
PIP (Picture-In-Picture) / Twin Picture
-PIP lets you view 2 different inputs (sources) on your TV screen at the same time. One source will be large, and the other source will show a smaller inset image.
-Twin Picture mode splits the screen into 2, allowing 2 picture sources to be shown on the TV screen at the same time. Each source is given half the screen.
-If you set the block/rating for Lock menu options in PIP/Twin Picture mode, “Rating Blocked” doesn’t display on screen.
Watching PIP/Twin Picture
Press the PIP button to access the sub picture. Each press of PIP changes the PIP options as shown below.
PIP Mode
Twin Picture Mode
PIP Off
Selecting an Input Signal Source for PIP/Twin Picture
Use the PIP INPUT button to select the input source for the sub picture. Each press of PIP INPUT button changes the PIP source. You can also select sources for the Sub Input in the SETUP menu.
| Main Picture Source |
|
| Available Sub Picture Sources |
|
|
|
|
|
|
|
| DTV, Analog |
|
| Video, and Front Video | |
Swapping the PIP/Twin Picture
Repeatedly, use the SWAP button to switch the main and sub pictures.
•Component 1, Component 2,
Main Picture
Sub Picture
Main Picture
Sub Picture
TV Program selection for PIP
1.Press the PIP button.
2.Select the Antenna or Cable option on the Sub input menu or with the PIP INPUT button. Use the PIPCH+ / PIPCH- button to select a channel for the sub picture.
(You can’t select TV for main and sub picture simultaneously).
34 DLP Projection TV