Presetting the Radio Stations

You can preset 50 stations for FM and AM (MW). Before tuning, make sure that you have turned down the volume.

1.Press BAND on the remote control until FM or AM (MW) appears in the display window.

2.And then every time you press BAND, FM and AM (MW) changes alternately.

3. Press and hold TUNING		or		on

the front panel for about two seconds until the frequency indication starts to change, then release.

Scanning stops when the DVD/CD Receiver tunes in a station. “TUNED” and “ST.” (for stereo program) appear in the display window.

4.Press MEMORY/STOP on the front panel.

A preset number will flash in the display window.

5. Press TUNING		or		on the front

panel to select the preset number you want.

6.Press MEMORY/STOP on the front panel again.

The station is stored.

7.Repeat steps 3 to 6 to store other stations.

To tune in a station with a weak signal

Press TUNING	or	repeatedly in step

3 to tune in the station manually.

To clear all the stored stations

Press and hold MEMORY/STOP for about two seconds and “CLEAR ALL” is appeared in the display window and then press MEMORY/STOP again, the stations are cleared.

If you have accidentally entered into the "CLEAR ALL" mode and you do not wish to clear the memory, do not press any key. After a few seconds, the "CLEAR ALL" display will go off by itself and change to normal mode.

Note:

If all stations have already been entered, the FULL message will appear in the display window for a moment and then a preset number will flash.

To change the preset number, follow the steps 5-6 as above.

Listening to the Radio

Preset radio stations in the DVD/CD Receiver’s memory first (see “Presetting radio stations” on the left).

1.Press BAND until AM (MW) or FM appears in the display window.

The last received station is tuned in.

2.Press PRESET +/- repeatedly on the remote control to select the preset station you want.

Each time you press the button, the DVD/CD Receiver tunes in one preset station at a time.

3.Adjust the volume by rotating VOLUME on the front panel or by pressing VOLUME + or - on the remote control repeatedly.

To turn off the radio

Press POWER to turn the DVD/CD receiver off or select another function mode (CD/DVD, AV 1, etc.,).

To listen to non-preset radio stations

Use manual or automatic tuning in step 2.

For manual tuning, press TUNING		or

on the front panel repeatedly.

For automatic tuning, press and hold TUNING

or		for about two seconds on the

front panel.

To select a preset radio station directly

You can use the number buttons on the remote control to select a preset radio station directly.

For example, to listen to preset station 4, press 4 on the remote control. To listen to preset station 19, press 1 then 9 (within 3 seconds).

For your reference

If an FM program is noisy

Press MONO/ST. on the front panel so that “ST.” disappears in the display window. There will be no stereo effect, but the reception will improve. Press the button again to restore the stereo effect.

To improve reception

Reorient the supplied antennas.