NEC NDV-28 owner manual Troubleshooting, Symptom Possible Cause Correction

Troubleshooting

Symptom		Possible Cause		Correction
No power.	•	The power cord is disconnected.	•	Plug the power cord into the wall outlet
				securely.
The power is on, but	•	No disc is inserted.	•	Insert a disc. (Check the disc indicator
the DVD player does				in the display window is lit.)
not work.
No picture.	•	The TV is not set to receive DVD	•	Select the appropriate video input
		signal output.		mode on the TV.
	•	The video cable is not connected	•	Connect the video cable securely.
		securely.
No sound.	•	The equipment connected with the	•	Select the correct input mode of the
		audio cable is not set to receive DVD		audio receiver so you can listen to the
		signal output.		sound from the DVD player.
	•	The power of the equipment	•	Turn on the equipment connected with
		connected with the audio cable is		the audio cable.
		turned off.
	•	The AUDIO options are set to the	•	Set the AUDIO option to the correct
		wrong position.		position, then turn on the DVD player
				again by pressing POWER.
The DVD player does	•	An unplayable disc is inserted.	•	Insert a playable disc. (Check the disc
				type and regional code.)
not start playback.
	•	The rating level is set.	•	Change the rating level.
The remote control	•	The remote control is not pointed at	•	Point the remote control at the remote
does not work properly.		the remote sensor on the DVD player.		sensor of the DVD player.
	•	The remote control is too far from the	•	Operate the remote control closer to
		DVD player.		the DVD player.
The picture is not	•	The progressive scan is ON at a	•	Turn Off the progressive scan.
		normal TV which cannot receive		See Page 11.
correct, such as double
		progressive scan.
picture, red picture or
no colour.	•	The TV OUTPUT SELECT (SETUP-	•	If connection is using Component
		DISPLAY) is set at S-Video, while the		(YPbPr), then ensure YPbPr is selected
		DVD is connected to YPbPr.		from (SETUP-DISPLAY-TV OUTPUT
				SELECT). See page 11.
	•	The TV OUTPUT SELECT (SETUP-	•	If connection is using S-VIDEO, then
		DISPLAY) is set at YPbPr, while the		ensure S-VIDEO is selected from
		DVD is connected to S-Video.		(SETUP-DISPLAY-TV OUTPUT
				SELECT). See page 11.

20