Picture Boost, OSD Setup, Extra, OSD Message

Demo

Enhances Area in half Picture.

Whether DEMO on or off, it is effected Full Enhance, Nature-Skin, Green-Field, Sky-blue, Auto Detect displays in the left side screen.

Picture Boost

Frame Size (When Bright Frame is ON)

Adjusts the Size of the Frame.

Note: The smallest size is 14.

Brightness (When Bright Frame is ON)

Brightness Adjustment for Enhance Area.

Contrast (When Bright Frame is ON)

Contrast Adjustment for Enhance Area.

Hue (When Bright Frame is ON)

Hue Adjustment for Enhance Area.

Saturation (When Bright Frame is ON)

Saturation Adjustment for Enhance Area.

Position (When Bright Frame is ON)

Adjusts the horizontal position of the Frame.

Adjusts the vertical position of the Frame.

Bright Frame

Enhances Area function.

Note: After Bright frame turns OFF to ON, the values of Frame Size recalls factory mode.

Bright Frame and the Frame Size do not store the position setting.

OSD Setup

H. Position

Adjusts the horizontal position of the OSD.

V. Position

Adjusts the vertical position of the OSD.

Timeout

Adjusts the OSD timeout.

Language

Sets OSD display language to English. (English is the default setting).

Extra

Input Select

Selects input source Ypbpr and HDMI for MFM.

Auto Adjust

Auto Adjusts the H/V Position, Focus and Clock of picture.

DDC/CI

Turns on or off the two-way communication between the graphics card and the monitor. With DDC/CI turned on, some monitor settings can be adjusted through the graphics card using a computer.

Reset

Clears each old status of Auto-configuration and sets the color temperature to Warm and recall.

Aspect

Sets up the rate of showing.

Information

Shows the resolution, H/V frequency, serial number and input port of current input timing.

OSD Message:

Auto Config Please Wait

1.When Analog signal input, if User Press Hot-Key ÒAutoÓ, will show this message, and the monitor do the auto configuration function. This message location is at the position setting in ÒOSD SetupÓ item.

2.When Digital signal input, without this OSD Message.

Input Not Support

When the Hsync Frequency, Vsync Frequency or Resolution is out of the monitor support range, will show this message. This message will be flying.

No Signal

When the video cable is not connected, or the video cable is connected but there is no active signal input, will show this message, after 9s the monitor will enter power saving. This message location is at the position setting in ÒOSD SetupÓ item.

OSD Locked

When the OSD is unlocked, keep holding down ÒMenuÓ key and ÒPowerÓ key once to turn on the monitor, the OSD will be locked and show this message. When the OSD is locked, only Power key function is still working, if user press other key will also this message.

When the OSD is locked, keep holding down ÒMenuÓ key and press ÒPowerÓ key once to turn on the monitor, the OSD will be unlocked an does not show message. This message location is at the position setting in ÒOSD SetupÓ item.

Input Signal

1.D-SUB: Analog PC source is selected.

2.DVI: Digital PC source is selected.

3.Ypbpr: Analog Video source (Component) is selected.

4.HDMI: Digital Video source (HDMI) is selected.

English-10