LCD22WMGX | LCD24WMCX | |
|
|
|
1 | SPDIF OUT | Outputs the Digital audio signal from HDMI (COAXIAL). |
|
|
|
2 | Component (Audio) | Connects Component Audio. |
|
|
|
3 | Component (Video) | Connects Component Video. |
|
|
|
4 | Headphone Jack | Connects headphones to the monitor. |
|
|
|
5 | AUDIO IN | Connects audio input from PC. |
|
|
|
6 | Connects to analog RGB input. | |
|
|
|
7 | Connects to digital RGB input. | |
|
|
|
8 | HDMI | Connects to digital HDMI signals. |
|
|
|
9 | AC IN | Connects power cord to monitor. |
|
|
|
10 | Kensington Lock Opening | Monitor can be secured using a Kensington locking system. |
|
|
|
Quick Start
To attach the Base to the LCD Stand:
1. Insert the front of the LCD stand into the holes in the front of the Base (Figure S.1).
2.Attach the Base to the Stand. The locking tab on the Base should fit into the hole on the back of the Stand (Figure S.1).
To attach the LCD monitor to your system, follow these instructions: |
|
1. Turn off the power to your computer. | Stand |
2.For the PC or MAC with DVI digital output: Connect the DVI signal cable to
the connector of the display card in your system (Figure A.1). | Locking Tabs |
For the PC with Analog output: Connect the
connected with the monitor to the connector of the display card in your system Base (Figure A.2). Tighten all screws.
Figure S.1
For the Mac: Connect the MultiSync Macintosh cable adapter (not included) to the computer. Attach the
NOTE: Some Macintosh systems do not require a Macintosh cable adapter.
Macintosh Cable Adapter (not included)
Figure A.1 | Figure A.2 | Figure A.3 |