Polaroid SVGA 270 Input Menu, Select video signal type, Select Execuet with the button, See above

OPERATIONS (continued)

Input Menu

The following functions are available when INPUT is selected on the

menu. Select an item with the and buttons, and start or stop

operation with the and buttons.

Table 1.4 Input Menu

SETUP	INPUT	IMAGE	OPT.
RGB		fH:38kHz
VIDEO		fV:60Hz
AUTO

Item		Description
	Displays RGB input frequency: Displays the horizontal and vertical sync
RGB	signal frequency for RGB input.
	* It is effective only at the time of input of RGB.
	Select video signal type:
	Select the signal type with the	and	buttons.
	Select NTSC, PAL SECAM, NTSC4.43, M-PAL, or N-PAL as appropriate
	for the input signal.
	Auto Adjust is valid at VIDEO/S-VIDEO input when AUTO is selected,
VIDEO	and is then used for automatic selection of the signal type.

*Use this function when the image becomes unstable (eg. the image becomes irregular, or lacks color).

*Auto Adjust requires approximately ten seconds. It may not function correctly with some input signals. Pressing the AUTO! button in this case may correct this problem.

Automatic adjustment at RGB input: Select EXECUET with the button. Horizontal position, vertical position, clock phase, and horizontal size are automatically adjusted when RUN is selected. Use with the window at maximum size in the application display.

	Automatic adjustment at VIDEO/S-VIDEO input:
AUTO	Select EXECUET with the button.
	A signal type appropriate for the input signal is selected automatically
	when EXECUET is selected. Valid only if AUTO is selected in VIDEO
	(see above).

*This operation requires approximately ten seconds. It may not function correctly with some input signals. Pressing the AUTO button in this case may correct this problem.

*This function is the same as for Auto Adjust in Basic operation.

1-12