Polaroid SVGA 270 manual Operations, Power On/Off, Power Off, Standby

Page 9

OPERATIONS

Read the "SAFETY INSTRUCTIONS" of this calligraphy and the separate volume well surely and use it for the safety before the use after attention.

Power On/Off

Power On

1.Confirm that power cord is connected properly.

2.Push "I" of the power switch. Standby mode is set up and power source indicator burns in the orange.

3.Push a control panel or "STANDBY/ON" of the remote controller. A warm-up is started and power source indicator goes on and off in green.

4.When power source on is completed, power source indicator finishes blinking, and burns in green. Open a Slide lens door.

5.Adjust picture size using the projection lens ZOOM knob.

6.Adjust focus using the projection lens FOCUS ring.

Make the power source of the computer ON before projector when using a RS-232 communications function.

STANDBY/ON Button

POWER Indicator

STANDBY/

ON Button

ZOOM knob

FOCUS ring

Power Switch

Slide Lens door

 

STANDBY/ON

VIDEO RGB

MENU

SELECT

MENU POSITION RESET

MAGNIFY

FREEZE VOLUME

 

 

Power Off

1.Push a control panel or "STANDBY/ ON" of the remote controller for about one second. The ramp of projector disappears and cooling of the ramp is started. Power source indicator goes on and off in the orange during ramp cooling. It is ineffective even if power source indicator pushes "STANDBY/ ON" button during the blinking.

2.When ramp cooling is completed, STANDBY mode is set up and power source indicator stops blinking, and burns in the orange. Confirm this, and push the "O"side of the power switch. Don't make power switch OFF when power source indicator burns in the orange except for the emergency. The time when power source indicator is green and power source OFF during the blinking shorten the life of projector lamp.

3.Power source indicator disappears when power source OFF is completed. Close without forgetting a lens door.

1-8

Image 9
Contents Svga LCD Projector Contents Features Contents of packageBefore USE Part Names Before USEVolume Loading the BatteryFirst Loading ReplacingInstallation of the Projector and Screen InstallationAngle Adjustment Installation ReferenceInstallation Power ConnectionCabling Plug & Play Example of system setupPower On Power On/OffPower Off OperationsOperations Basic OperationBasic Operation Description Set/Clear Mute mode Press the Mute Volume adjustment Reduce VolumeAutomatic adjustment at VIDEO/S-VIDEO input Normal menu Single menuSetup Menu Description Setup MenuInput Menu Select video signal typeInput Menu Select Execuet with the buttonImage Menu Image MenuOptions Menu Options MenuSelect menu background color Select with Select menu display language Select withNo Signal Menu No Signal MenuElectric shock High temperature Mechanical shock MaintenanceLamps Lamp LifeMaintenance Resetting the Lamp TimerReplacing the Lamp Other Maintenance Air Filter MaintenanceInside maintenance Maintenance of the lensMessage Contents TroubleshootingOSD Message Mssage display listIndicators Message TroubleshootingIndicators Message list IndicatorSymptom 10. SymptomSymptom Possible cause Remedy Specifications 11. SpecificationsAudio Specificationsc Warranty and AFTER-SERVICEDimension Diagram Regulatory Notices FCC Statement WarningFor the Customers in Canada Technical Example of computer signalTechnical Initial set signals