Hitachi 32UDX10S, 36UDX10S manual Using the Remote to Control Satellite Receiver Functions

USING THE REMOTE TO CONTROL SATELLITE RECEIVER FUNCTIONS

Operating the precoded function for your satellite receiver.

This remote is designed to operate different types of satellite systems. You must first program the remote to match the remote system of your satellite receiver. (refer to page 33)

1.Turn ON your satellite receiver.

2.Aim the remote control at the front of your satellite receiver.

3.Press and release the SATELLITE (SAT) button to switch to satellite pre-coded mode.

4.Hold down the SAT button on the remote and enter the two digit preset code that matches your satellite receiver as shown on page 33. The indicator light will flash 3 times if the code was accepted.

5.Aim the remote at the satellite receiver and press the POWER button. The remote will turn off your satellite receiver when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your satellite receiver. If the satellite receiver does not turn off, try a different two digit preset code.

6.The remote will now control your satellite receiver.

NOTES:

1.If your satellite receiver cannot be operated after performing the above procedures, your satellite receiver code has not been precoded into the remote.

2.In the unlikely event that your satellite receiver cannot be operated after performing the above procedures, please consult your satellite receiver operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

4.The INPUT button will act as the TV/SAT button when in SAT mode.

		POWER
TV			VCR		CBL		SAT
			SOURCE WIZARD
DVD			AV1		AV2		AV3
	1			2		3
	4			5		6
	7			8		9
SLEEP				0			LAST CH
INPUT	C.C			HELP	ASPECT		C.S.
			MENU		EXIT
VOL			SELECT			CH
SVCS			MUTE	RECALL		SCHD
		VCR	PLUS+
				INFO	GUIDE/TV

SATELLITE (SAT) button

This button allows the remote to control your satellite receiver by setting it to SATELLITE mode.

PRECODED SATELLITE RECEIVER buttons

These buttons transmit the chosen precoded satellite codes.

EXCLUSIVE TV buttons

These buttons are for operating the TV.

PIP PIP CH FREEZE

	PIP ACCESS
PIP MODE	SWAP

PROG TV/VCR SLOW

REC

CLU-577TSI

MY SATELLITE RECEIVER CODE IS:

NOTE: Refer to instruction manual of the Satellite Receiver for operation of the buttons exclusively for the Satellite Receiver.

30