Hitachi 42HDF39 important safety instructions Rear Panel Main Power Switch & Jacks

Page 14

REAR PANEL MAIN POWER SWITCH & JACKS

REAR VIEW

42” PLASMA TV

English

Français

①MAIN POWER button

This power button is for the complete system, and must be turned ON/OFF manually. It is recommended to leave the “MAIN POWER” to ON condition (lights red) for stand-by mode.

②AC IN input

This TV is designed to operate on 120VOLTS 60Hz AC current. Insert the TV power cord into a 120VOLTS 60Hz outlet.

③Service Terminal (1) Input

For factory adjustment and service, please DO NOT connect here.

④ANALOG RF Input

RF input that connects to the antenna, cable box, or CATV cable. Supports NTSC TV system.

⑤Y-PBPR /Y-CBCR- Audio Input

Connect audio for Component input (if you have mono sound, insert the audio cable into the left(L) audio jack).

⑥S-VIDEO - Audio Input

Connect audio for S-Video input (if you have mono sound, insert the audio cable into the left(L) audio jack).

⑦COMPOSITE - Audio Input

Connect audio for Composite input (if you have mono sound, insert the audio cable into the left(L) audio jack).

⑧Y-PBPR /Y-CBCRInputs

Provide Y-PBPR /Y-CBCRjacks for connecting equipment with this capability, such as a DVD player or Set Top Box.

13

Image 14

Contents Operating Guide for 42HDF39 Important Safety Instructions EnglishPublic Viewing of Copyrighted Material Read before operating equipmentPrevention of Screen Burn Use only the correct power outlet Typical SymbolsNever use the Plasma Television if a problem should occur Do not insert liquids or foreign objectsBe careful in handling the battery of the remote control Be cautious of the power cord connectionBe sure to keep safety ground connection Installation environment Avoid a high temperature environmentRemove the power cord for complete separation How to view the Plasma TelevisionDo not physically impact the remote control Precautions for the cable connectionPrecaution during transportation Set the sound volume at a suitable levelAccessories BatteriesLocation HOW to Setup Your NEW Hitachi Plasma TelevisionAntenna Viewing Hookup Cables SUB Mini 15-Pin Cable ProvidedVHF 300-Ohm antenna/UHF antenna When both VHF and UHF antennas are connectedVHF 75-Ohm antenna/CATV Cable TV Front Panel Controls Rear Panel Main Power Switch & Jacks Rear Panel Jacks Connecting External Sources Connecting AN Digital TV AntennasConnecting Hdtv Sources Connecting a TV Cable BOX or Satellite Receiver Connecting a DVD Player Connect the DVD player using Hdmi cable orConnecting a VCR Connecting a Audio Receiver Connecting PC VGAConnecting External Audio Amplifier Tips on Rear Panel Connections HOW to USE the Remote To Control Your Plasma TV Ntsc button VOLUME+/- buttonsVideo button DTV buttonAspect button Freeze button24. C.C button PIP Swap button 26. P. Mode buttonZoom +/- buttons PIP Input buttonAudio/Video Mode PC ModeVideo Function Options PC Mode Video Function OptionsVideo Image Function Options PC Mode Image Function OptionsImage Language Function Options AudioAudio Function Options System Function Options PC Mode System Function OptionsSystem Chip Setting UP the V-CHIPChange Password Number TV Guidelines BlockingTV Channel Setup Setting UP the Closed CaptionSetting UP the TV Channels Closed CaptionATSCAdvanced Television System Committee Introduction Atsc Receiver FunctionsAuto Scan Setting UP Your DTVChannel Manual Scan EditLock SetupCaption RatingChange Password Reset DefaultCare of Your Hitachi Plasma Television Your Remote Control Do notReception Problems Ignition NoiseUseful Info Plug and Play Trademark AcknowledgmentUseful Info Agency Regulatory InformationVideo Features Supplied AccessoriesOptional Accessories AudioDial Toll Free Home Electronics DivisionHitachi END User License Agreement for Hitachi DTV Software END User License Agreement for Hitachi DTV Software