Hitachi LE32H405 Connections to other equipment, To connect a Hdmi or a DVI device to the unit

Connections to other equipment (continued)

To connect a HDMI or a DVI device to the unit

The HDMI/DVI input receives digital audio and uncompressed video from a HDMI device or uncompressed digital video from a DVI device.

When you connect to a DVI device with a HDMI-to-DVI adapter cable, it transfers only video signal. Separate analog audio cables are required.

Back of the unit

To PC/DVI AUDIO IN

!

RGB/_AUDIO.D.I1/ovl

,"--J RGB I

Audio cord (not supplied) To DVI output

DVI device

HDMI - to - DVl adapter cable

(HDMI type A connector) (not supplied)

To HDMI/DVI IN or

HDMI device

HDMI cable (type A connector) (not supplied)

To HDMI out

When using a HDMI input from a Set-Top-Box, it is recommended to use a 1080p, 1080i or 720p input signal.

When the HDMI input is a 1080p signal, it is recommended that the length of the cable should be less than 5 meters.

Using an AV Amplifier with built-in digital surround

If you are using an Amplifier with built-in digital surround sound, you can enjoy various audio systems including Dolby Digital Surround audio that sounds just like the movie.

Connect an AV amplifier with built-in Dolby Digital decoder, DTS decoder, or MPEG decoder etc. as shown below.

	Rear of the unit
	®						Front Speak-
						Subwoofer	er (Right)
	DIGITALOUT(COAXIAL)
		Speaker _	\	(_\
To		(Left)Fr°ntFL\_ _\_		_.	TV	_/__o
COAXIAL	OUT
Coaxial digital cable---_
(not supplied)/
To Coaxial_ I					\	Center Speaker
Digital Audio Inputq
	"N
AV A_ i:_,_t	__-'On_-gi_als_--rroundu_	_			SpeakerSurround (Left)	_	SpeakerSurround (Right)

decoder as listed above

len you are viewing digital broadcast, this unit will not work in conjunction with DTS audio or MPEG audio. There will be no sound output if connected to an AV amplifier with a built-in DTS decoder or MPEG decoder..

20