Hitachi 42HDS52, 55HDS52 Remote Control for Additional Audio Equipment, Precoded Audio Buttons

Page 35

The Remote Control for Additional Audio Equipment

Operating the precoded function for your Audio component.

This remote is designed to operate different types of Audio component. You must first program the remote to match the remote system of your Audio component (refer to pages 37-38 for pre-codes).

1.Turn ON your Audio component you wish to control with the Remote.

2.Aim the remote control at the front of your Audio component.

3.To switch to Audio (AMP) component pre-coded

mode, use the SOURCE ACCESS buttons ( or ) on the remote control to position the LED light to the corresponding selection.

4.Hold down the ENT button on the remote and enter the four digit preset code that matches your Audio component, as shown on pages 37-38. Release the ENT button. The indicator light will flash 3 times if the code was accepted.

5.Aim the remote at the Audio component and press the POWER button. The remote will turn off your Audio component when the correct four digit preset code is entered. When this occurs, the remote control is programmed for your Audio component. If the Audio component does not turn off, try a different four digit preset code.

6.The remote will now control your Audio component.

7.Repeat steps 1 - 6 if you wish to program the remote to control another Audio component.

NOTE: 1. If your Audio component cannot be operated after performing the above procedures, your Audio component code has not been precoded into the remote.

2.In the unlikely event that your Audio component cannot be operated after performing the above procedures, please consult your Audio component operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

PRECODED AUDIO Buttons

These buttons transmit the chosen precoded Audio component codes.

EXCLUSIVE TV Buttons

These buttons are for operating the TV.

MY AUDIO COMPONENT

CODE IS:

NOTE: Refer to instruction manual of the VCR/PVR for operation of the buttons exclusively for the VCR/PVR.

The Remote Control

35

Image 35

Contents Plasma Television Read Before Operating Equipment Important Safety InstructionsFor More INFORMATION, Call 1-800-HITACHI For U.S. models AccessoriesRemote Control Battery Installation and Replacement Location How To Set Up Your New Hitachi Plasma TelevisionConnect Power Swivel Cable AntennaAntenna Connections to Rear Jack Panel ViewingHook-up Cables and Connectors Mode Indicator Quick Reference Remote Control Buttons and FunctionsFront/Rear/Side Panel Controls Side Input Jacks for Video Power light indicatorRemote Control sensor Learning AV NET sensorMonitor OUT & HI-FI Audio OUT Rear Panel ConnectionsCableCARD Slot Upgrade CardTo Power Swivel Connector Subwoofer OutLeft Side Panel Connecting External Video SourcesOn-Screen Display The Remote Control First time use Macrovision Notes Tips on Rear Panel ConnectionsConnecting AN S-VIDEO and Stereo Audio Source to Input 1, 2 Connecting a Video and Stereo Audio Source to INPUT1 INPUT5Hdmi input See page 15 for tips on Rear Panel Connections Connecting Monitor OUT Connecting External Audio/Video DevicesConnecting AN External Audio Amplifier Rear Panel Jacks Automatic Mode Default mode Remote ControlSource Access ENT button How to Use the Remote to Control Your TVMode Indicator Source Access or buttonsZOOM1/ZOOM2 StandardExpanded AIR ANALOG/DIGITAL ChannelsPhoto Input Cursor PADRotate Dash button Volume VOL WHEEL, Mute buttonLast Channel Last CH button Channel CH WHEEL/CHANNEL Selector buttonsPIP button Picture-in-Picture PIPPIP PIP Mode PICTURE-IN-PICTURESplit Mode PICTURE-IN-PICTURE Surf Mode PICTURE-IN-PICTUREStrobe Freeze Split FreezeMain Freeze Exclusive TV buttons Remote Control for Cable Box FunctionsOperating the precoded function for your cable box Precoded Cable BOX buttonsSET-TOP-BOX Code is Remote Control for Set-Top-Box/Satellite Receiver FunctionsPRE-CODED SET-TOP-BOX/SATELLITE Receiver buttons MY Satellite ReceiverMY DVD Player Code is Remote Control for DVD FunctionsOperating the precoded function for your DVD player Precoded DVD ButtonsMY VCR/PVR Code is Remote for VCR/PVR FunctionsPrecoded VCR/PVR Buttons MY Audio Component Code is Remote Control for Additional Audio EquipmentOperating the precoded function for your Audio component Precoded Audio ButtonsInput Access How to Use the ENT ButtonVCR Brand Code Remote Control CodesSET TOP BOX BRAND..CODE On-Screen Display Video Video Black Enhancement Color TemperatureContrast Mode Auto Movie ModeSet Black Side Panel Reset Video SettingsBBE AudioSRS DRC Start or Clear option Signal MeterChannel Manager Auto Channel ScanWhich are your Favorite FAV Channels Channel ListLocks Change Access CodeMotion Picture Ratings Table Movie RatingsTV Parental Guide Ratings Table TV RatingsUse the Cursor PAD , or Channel Canadian Ratings English Table Canadian Ratings EngCanadian Ratings French Chart Set The Clock TimersSet Day/Night Timer Set Sleep TimerSelect Start Time AM/PM Use the Cursor PAD Set Event TimerEvent 2, Event 3, Event 4 and then press Select Start Time HOUR/MINUTEMenu Language SetupMenu Preference Screen Saver Image PowerScreen Saver Picture’s Movement Automatic Power Saving Menu BackgroundRemote Set The InputsInput 4 Auto Link AutoAV NET Setup Wizard Example A/V Receiver Setup NET Setup AV NET Setup Wizard Example DVD Setup Learning Mode Learning Mode Example A/V Receiver SetupUse the Cursor PAD To select Soft Key to learn Ex. VOL Select the Test button VOL Learning Mode Example CUSTOM/DVD 3 Setup Power Menu Select Exit On-Screen Analog Captions Caption ModeSet Closed Caption Caption DisplayFixed Set Monitor OutMonitor TV Tuner OutInsert MMC Card UpgradesUpgrade NOW Quick Start Up Power SwivelDo not Equipment Care and TroubleshootingTroubleshooting Switch ON/OFF Switch onceReception Problems Troubleshooting Agency Regulatory Information Useful InfoFeatures Audio Features and SpecificationsSet Dimensions Canada 1-800-HITACHI HitachiHome Electronics Division Digital Media DivisionEND User License Agreement for Hitachi DTV Software End User License Agreement for Hitachi DTV SoftwareImage Input Type Format Aspect Video ID Auto Aspect AppendixesInformation and press the Select button Appendix EHdmi IndexPage Page Page Page Page QR64864