Hitachi 60V710, 50V715 Read before operating equipment, Public Viewing of Copyrighted Material

Page 3

IMPORTANT SAFETY INSTRUCTIONS

Read before operating equipment

Follow all warnings and instructions marked on this television.

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with a dry cloth.

7.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or ground- ing-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched par- ticularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11.Only use the attachments/accessories specified by the man- ufacturer.

12.

Use only with the cart, stand, tripod, brack-

 

et, or table specified by the manufacturer,

 

or sold with the apparatus. When a cart is

 

used, use caution when moving the

 

cart/apparatus combination to avoid injury

 

from tip-over.

13.Unplug this apparatus during lightning storms or when unused for long periods of time.

14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15.Televisions are designed to comply with the recommended safety standards for tilt and stability.

Do not apply excessive pulling force to the front, or top, of the cabinet which could cause the product to overturn resulting in product damage and/or personal injury.

16.Follow instructions for wall, shelf or ceiling mounting as rec- ommended by the manufacturer.

17.An outdoor antenna should not be located in the vicinity of overhead power lines or other electrical circuits.

18.If an outside antenna is connected to the receiver be sure the antenna system is grounded so as to provide some protec- tion against voltage surges and built up static charges. Section 810 of the National Electric Code, ANSI/NFPA No. 70-1984, provides information with respect to proper ground- ing for the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding connectors, location of antenna-discharge unit, connection to

grounding electrodes and requirements for the grounding electrode.

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿

￿￿￿￿￿￿

￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

Note to the CATV system installer: This reminder is provid- ed to call the CATV system installer’s attention to Article 820- 40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Do not place any objects on the top of the television which may fall or cause a child to climb to retrieve the objects.

This product contains lead and a lamp that contains mercury. Dispose of this product and its lamp in accordance with applicable environmental laws. For lamp recycling and disposal information, go to www.lamprecycle.org. For product recycling and disposal information, contact your local government agency or the Electronic Industries Alliance at www.eiae.org (in the US) or the Electronic Product Stewardship Canada at www.epsc.ca (in Canada).

For more information, call “1-800-HITACHI.”

PUBLIC VIEWING OF COPYRIGHTED MATERIAL

Public viewing of programs broadcast by TV stations and cable companies, as well as programs from other sources, may require prior authorization from the broadcaster or owner of the video program material.

This digital television is capable of receiving analog basic, digital basic and digital premium cable television programming by direct con- nection to a cable system providing such programming. A CableCARD provided by your cable operator is required to view encrypted digital programming. Certain advanced and interactive digital cable services such as video-on-demand, a cable operator’s enhanced program guide and data-enhanced television services may require the use of a set-top box. For more information call your local cable company.

This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited consumer uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited.

3

Downloaded from www.Manualslib.com manuals search engine

Image 3
Contents Operating Guide for 42V710, 50V710, 60V710 42V715, 50V715 Refer Servicing to Qualified Service Personnel Important Safety InstructionsPublic Viewing of Copyrighted Material Read before operating equipmentFirst Time USE AccessoriesHOW to SET UP Your NEW Hitachi LCD Rear PTV Antenna Connections to Rear Jack Panel HOOK-UP Cables and ConnectorsPhoto Input Side Panel ControlsTemp indicator Power lightSide Panel Jacks and Connectors Rear Panel Jacks TV AS Center Inputs Upgrade CardOptical Out Digital Audio RS232C InputCableCARD CableCARD SlotRear Panel Connections Typical FULL-FEATURE SetupTips on Rear Panel Connections Rear Panel of Television Connecting External Audio DevicesConnecting External Video Devices Connecting a Monaural Audio Source to INPUT1~INPUT5Before Operating External Video Source CableCARD Connecting a Stereo Source to INPUT1~INPUT5TV AS Center Connecting AN S-VIDEO Source to Input 3, 4First Time USE Connecting a Component Source to Input 1 or 2 Y-PBPR Remote Control Source Access ENT button HOW to USE the Remote to Control Your LCD Rear PTVMode Indicator Source Access F , E buttonsStandard Aspect buttonGuide button DAY/NIGHT buttonPICTURE-IN-PICTURE button Menu buttonPhoto Input Ant B Ant a Inputs buttonPhoto Input JumpRotate SlideshowWhen a S-VIDEO Info buttonVideo Last Channel LC button Volume VOL WHEEL, Mute buttonChannel CH WHEEL/CHANNEL Selector buttons Dash buttonPOP Mode PICTURE-IN-PICTURE PICTURE-IN-PICTURE PIPPIP button Ntsc PIP Mode PICTURE-IN-PICTURESplit Mode PICTURE-IN-PICTURE Surf Mode PICTURE-IN-PICTUREMain Freeze Split FreezeStrobe Freeze Exclusive TV buttons Using the Remote to Control Cable BOX FunctionsOperating the precoded function for your cable box Precoded Cable BOX buttonsPRE-CODED SET-TOP-BOX/SATELLITE Receiver buttons Using the Remote to Control DVD Functions Operating the precoded function for your DVD playerPrecoded DVD Buttons Precoded VCR/PVR Buttons Using Your Remote To Control VCR/PVR FunctionsUsing Your Remote To Control Additional Audio Equipment Operating the precoded function for your Audio componentPrecoded Audio Buttons Control Input AccessDVD Brand Audio Brand ON-SCREEN Display OSD Video Audio Aspect Channel Video Picture ModeVideo Color Management Reset Video SettingsNoise Reduction Auto Movie Mode Color DecodingAuto Color Audio Treble Bass BalanceTechnology Audio Source Internal Speakers Auto Noise Cancel Perfect Volume LoudnessDRC Language Digital OutputAspect Auto AspectVertical Position Channel Manager Set The AntennaAuto Channel Scan Channel List Signal MeterLocks Movie Ratings TV Ratings Canadian Ratings Eng Canadian Ratings English ChartCanadian Ratings Frn Set The Clock TimersSet Day/Night Timer Set Sleep TimerPlease Set Clock First Set Event TimerSet Auto Power Off Menu Preference SetupScreen Wipe Set Menu BackgroundScreen Saver OptionSet The Inputs Set Black SidePanel Caption Mode Set Closed CaptionChannel Set Monitor Out CableCARD InfoSet AV Control Quick Start Up UpgradesLamp Type LM500 Lamp Replacement120V Screw Lamp Cover Phillip Head Screw Driver 120V Do not Care of Your Hitachi Television Your Remote ControlIgnition Noise Reception ProblemsUseful Info Symptoms42V715 50V715 Dimensions 42V710 50V710Inputs OutputsHome Electronics Division Dial Toll FreeDigital Media Division DVI Input IndexEND User License Agreement for Hitachi DTV Software END User License Agreement for Hitachi DTV Software Page Page QR60542
Related manuals
Manual 84 pages 22.12 Kb