Hitachi 32HDT55 CD, PVR, AMP buttons, Channel selector buttons, Sleep button, Info button

Page 26

HOW TO USE THE REMOTE

TO CONTROL YOUR PLASMA TV

CD, PVR, AMP buttons

When pressed, each of these buttons will blink to indicate the remote is in Audio mode (see page 39).

CHANNEL selector buttons

CHANNEL selector buttons are used to select channels, lock access code, etc.

Enter one, two, or three numbers to select channels. Enter “0” first for channels 1 to 9, or simply press the single digit channel you wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the “1” button, wait until two dashes appear next to the channel display on your TV, then enter the remaining two numbers using the number buttons.

Channel selection may also be performed by pressing CH up ( ) or down ( ).

NOTE: The Plasma TV may not receive some channels if you are not in the correct ANTENNA/CABLE mode (see page 50).

SLEEP button

Press this button to display the sleep timer in the lower center of the screen. Every subsequent press of this button will add 15 min- utes to this timer, up to a maximum of three hours. Once set, use INFO when you want to view time remaining. If the SLEEP but- ton is pressed while the timer is set, it will reset to the original condition.

INFO button

Press this button when you want to check the channel being received, the picture source, if the channel has stereo (ST) or second audio program (SAP), the time, CHANNEL ID and if the SLEEP timer is set.

REMOTE CONTROL

Day/Night

Closed Mode

Captioning

3:32 PM

Time

Ant A 22

Main Picture Source

Stereo

Audio Broadcast

R

Broadcast Rating

1080i Format

Signal Format

Wide

Day

4:3 Expanded

Mode

CC Off

0:00 AM

-:--

Sleep Timer

View

Zzzz

3:32 PM S-IN:3

VID 3

3:32 PM YPBPR:1

VID 1

When an S-VIDEO Input is connected to VIDEO: 3.

When a COMPONENT VIDEO: Y-PBPRInput is connected to VIDEO: 1.

THE

Off Timer

ANTENNA button

The ANT button will select between Antenna A and Antenna B each time the button is pressed.

3:32 PM
Ant A 15	ANT
Stereo	ANT
G
G

TV/RGB button

Press this button to toggle between RGB (Analog) mode and TV mode.

3:32 PM

Ant B 22

Stereo

R

26

Image 26

Contents Using the RGB Input Important Safety InstructionsRemote Control First Time USEPower Source Public Viewing of Copyrighted Material Safety TipsPrevention of Screen Burn Accessories First Time USEFirst Time HOW to Setup Your NEW Hitachi Plasma TelevisionSpeaker Installation USEAntenna Time USEFirst LocationHOW to SET UP Your NEW Hitachi Plasma Television ViewingHookup Cables Antenna Connections to Rear Jack PanelMENU/SELECT button Volume levelFront Panel Controls INPUT/EXIT buttonPhones Jack Audio OUT Rear Panel JacksMonitor OUT RGB Audio Input SUB-POWER buttonRGB Analog Input DVI Hdtv Digital InputConnecting Plasma Display Monitor to AVC BOX Connecting External Video SourcesBefore Operating External Video Source Connecting External Video SourcesConnecting a Monaural Audio Source to INPUT2~INPUT5 Connecting a Stereo VCR or Stereo Laserdisc Player Connecting S-VIDEO VCR or Laserdisc Player Rear Panel of AVC CenterSee page 23 for tips on Rear Panel Connections Connecting External AUDIO/VIDEO Devices Connecting External Audio AmplifierConnecting AV Network AV Network Setup Wizard Hitachi AV NET SET UPAUDIO/VIDEO Codes for AV Network not for remote control Rear Panel Connections Rear Panel of Display MonitorTips on Rear Panel Connections Light Button Remote ControlRemote SET-TOP-BOX STB HOW to USE the Remote to Control Your Plasma TVCable CBL Sleep button CD, PVR, AMP buttonsChannel selector buttons Info buttonAV NET button RemoteControl HOW to USE the Remote To Control Your Plasma TV AV NET Learning WizardAspect button ExpandedMenu button VOLUME, Mute buttonVideo button Exit buttonSurf button Last Channel Last CH buttonPICTURE-IN-PICTURE buttons 23 VID1 ~ VID5PIP button Split Mode PIPPICTURE-IN-PICTURE PIP PIP Mode button POP Mode PIPPIP Mode PIP Swap button with PIP onStrobe FREEZEwith PIP OFF Freeze button With PIP OFFSplit FREEZEwith PIP off POP Main Freeze with PIP OFFPrecoded VCR Buttons Using the Remote to Control VCR FunctionsOperating the precoded function for your VCR Exclusive TV ButtonsCable CBL button Using the Remote to Control Cable BOX FunctionsOperating the precoded function for your cable box Precoded Cable BOX buttonsSET-TOP-BOX STB button Precoded SET-TOP-BOX/SATELLITE Receiver but- tonsPrecoded DVD Buttons Using the Remote to Control DVD FunctionsOperating the precoded function for your DVD player Using Your Remote To Control Additional Audio Equipment Operating the precoded function for your Audio componentSimple Remote Control AV NETAUDIO/VIDEO Codes For Remote Control only VCR BRAND. . . . . . . . . . . . . . . . . CodeOSD On-Screen Dispaly ON-SCREEN DisplayOSD On-Screen Display Picture Mode VideoUse the Thumb Stick Pure depending on the user’s preference Reset Video SettingsColor Management Noise Reduction Auto Movie Mode Color DecodingBass AudioTreble BalanceAuto Aspect Aspect ModeAspect Vertical PositionReception Band Channel ManagerChan. Manager Auto Channel Scan Screen Display ScanChannel ID Locks LocksMovie Ratings TV Ratings Eng Canadian Ratings English ChartCanadian Ratings Canadian Ratings Frn Setup Menu PreferenceScreen Saver Image PowerMenu Background Set The Clock Set The ClockSet The Inputs Set The InputsVideo 2 Auto Link Set The Color SystemSet Event Timer Please Set Clock FirstClosed Caption Using the RGB Input RGB on Screen DisplayOperation No SYNC. Signal Invalid Scan Freq TV/RGB Video Aspect Setup Contrast RGB on Screen DisplayRGB Input BrightnessReset AspectAuto Adjust PositionClock Phase Horizontal ClockInput Level Using the RGBReal and Normal signals in Standard Mode Black SideCare of Your Hitachi Plasma Display Your Remote Control Useful InformationUseful Info Ignition NoiseUseful Info Symptoms ControlPlug and Play Trademark AcknowledgmentAgency Regulatory Information Features UsefulDial Toll Free Home Electronics DivisionDigital Media Division Index Page Page Page QR57371