Hitachi 55PD8800TA, 42PD8800TA user manual Troubleshooting Symptom and Check List, 41 ~

42PD8800TA 55PD8800TA

TROUBLESHOOTING (continued)

Symptom and Check List (continued)

Symptoms		Check list	Page
No picture	Check if the Power Cord is plugged into the socket fi rmly.		17 ,	18
The Indicating lamp → Off	Check if the Main Power is ON.
	Check if all the cables of the external equipments are connected
No picture	correctly and fi rmly.
	Check if the power of the external equipments is ON.
The Indicating lamp → Orange			52
	Check if the TV/AV mode has been selected correctly.
It means that the unit is in “Power Save
	Check if the PC is in Power Save mode or not.
mode”.
	Refer to “Power Save mode” and “When following messages appears on
	the screen”.
No picture	Check if the signal cable is connected correctly and fi rmly.		14 ~ 16
The indicating lamp → Green	Adjust the level of Brightness and Contrast lower.
The top of the monitor and surface of	It may happen when you use the unit for long hours. Turn off the Main		57 ,	59
the panel heat up.	Power of the unit for a while. Please note that this is not malfunction.
Image cannot be displayed in the correct	Press	button to check if the input signal of the displayed image is	25 ,	57 ,
position.	compatible with the specifi cation of the monitor.		59

When the VCR is in special playback

It could happen when the VCR is connected to Component output, such

features (Fast Forward or Rewind), the

screen gets dark and cannot see the

as 480i. This is not malfunction.

image at all.

Try Composite output or S-video output and check the picture again.

	There are some combinations of input signals that the images are not
The images are not displayed on sub	displayed on sub pictures.	41 ~ 43
pictures in “Multi Picture mode”	Please check the Table of “2-Picture” and “4-picture/2-picture(1080i)” for		60
	details.
	The display size is fi xed at “FULL” when the receiving signals are
Screen display size cannot be switched	1080i/60Hz, 1080i/50Hz, 720p/60Hz, or 720p/50Hz.		, 39
correctly.	Check the signal status by pressing the	38
		button on the remote
	control.
	Check if the cables are connected correctly.
Cannot be displayed the image from	Check the output format of the equipments.	57	~ 59
HDMI 1 or 2.
	(Please refer to “Connecting Procedure” and “Recommended Signal
	List”.)

55

HITACHI

PW3-12th-P51-P60.indd 55 2005/11/14 13:38:38