Hitachi 26LD8000TA user manual Accessories, Remote Control Battery Installation and Replacement

Page 9

ACCESSORIES

Check to make sure you have the following accessories before disposing of the packing material.

REMOTE CONTROL POWER CORD USER’S GUIDE

2. 3.

BATTERIES

4.

ENGLISH

1.

CAUTION: Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate ventilation for the electronics or proper support for the front glass panel. This LCD television product is designed for a maximum tilting angle of 20 degrees from vertical.

1.Remote Control Unit

2.Power Cord

3.User’s Guide

4.Two “AAA” size, 1.5V batteries

REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT

1.Open the battery cover of the remote control by pressing the notched part of the cover with your fingers and pulling the cover off.

2.Insert two new “AAA” size batteries for the remote control. When replacing old batteries, push them towards the springs and lift them out.

3.Match the batteries to the (+) and (-) marks in the battery compartment.

4.Replace the cover.

9

Image 9
Contents English Software Notice FeaturesContents About the Symbols Safety InstructionsBe cautious of the power cord connection Safety Instructions About the SymbolsPrecautions Prevention of an obstacle to Radio receivers About screen defects Using in low temperaturesAbout residual images About the panel screenRemote Control Battery Installation and Replacement AccessoriesPower Cord HOW to Setup Your NEW Hitachi LCD TelevisionAntenna Front View Front Panel ControlsTOP Side View TOP Side Panel Controls① Main Power button Rear Panel Main Power Switch & JacksNormal mode Side View Side Panel ControlsConnecting External Sources Connecting External Sources PBPRcable Turn the Television On or Off Choose a Television Channel Remote Control Buttons and FunctionsAdjust the Volume Watch Images from External EquipmentDisplaying the Source Information Sleep Timer Function Picture ModeAspect Ratio POP / PIP Functions Remote Control Buttons and Functions Cancel Teletext FunctionIndex RED/GREEN/YELLOW/BLUE Operation with the buttons on the TV OSD On-Screen DisplayPicture Adjustment Picture Setting Picture modeSound Setting Sound AdjustmentManual Auto Channel Scan Initial Setup LanguageName Channel ListInsert Delete Press the S/T buttons to choose a teletext language DVI support timing 26LD8000TA 2 / PC Supported Mode ListAudio PC PicturePoor picture Self Diagnosis FunctionOther concerns PALI, D/K, B/G , SECAMD/K, B/G, Ntsc M Product SpecificationsProduct Specifications Signal Input RGB terminal D-sub 15-pin connectorInput connector pin specifications With component input AV1, AV2 input With Analog signal input RGB input
Related manuals
Manual 42 pages 33.65 Kb Manual 54 pages 481 b