Extron electronic CTP150CM UL Requirements for Wall Box Installation, Power source, if necessary

Instaltal lationandandOperation,cont’d

Installation Overview

CAUTION Installation and service must be performed by authorized personnel only. UL Listed electrical boxes are recommended. See UL Requirements for Wall Box Installation in this chapter.

1	Power off all devices and disconnect them from the
	power source, if necessary.
2	Run an 8-conductor cable between the site where the

UL Requirements for Wall Box Installation

The following Underwriters Laboratories (UL) requirements pertain to the installation of the CTP150CM into a wall or furniture (figure 2-1).

Installation

Cable

Conduit

CTP150CP control panel module will be installed and the

site of the TPT150 transmitter.

3 For installation in a wall or furniture, prepare the site:

cut a hole in the surface, install the electrical box or

mounting bracket, and prepare the cables. See Wall

Mounting Site Preparation in this chapter. See Mini-AAP

mounting options in appendix A, Reference Information, for a

partial list of devices that can accept four space mini-AAPs.

4 For other installations, install a tabletop or in-table

connector bay, or other mini-AAP mounting option.

								TOR
							JECR
							O	WE
							PRPO
					PC	1
								E
					PC	2		LUM
							VOUP
			H	. SHIFT				E
					EO		1	LUM
		SELECT			VID		DO
	INPUT			MIN/MAX	VID		2
					EO
1
2		DIO	2
		AU	MONITOR					™
	2
INPUT								ADSP
								WITH

AU	1	Mxi
	DIO	478
1		RGB
INPUT

2.5"	Extron
	RGB 478 Mxi
	Interface

Extron CTP150CP

Remote Control Panel

Refer to the manual for the device in which the control

panel module will be installed. See Mini-AAP mounting

options in appendix A, Reference Information, for a partial list

of devices that can accept four space mini-AAPs.

5 Connect the 8-conductor cable between the remote

control panel and the transmitter. See Rear Panel Setup, in

this chapter for details.

If the rear of the control panel module will be inaccessible when the installation is complete, the operation of the panel should be tested before the final mounting.

6Apply or connect power to all devices in the system.

7Test the system: Ensure that the transmitter responds as desired to the remote control panel buttons. If necessary, correct the system wiring. Ensure that you remove electrical power if you need to change the system wiring. Test the system again.

8Mount the control panel module into any Extron four- space mini-AAP connector panel.

9Restore power to all devices.

Figure 2-1 — CTP150CM in a four-gang wall box

1.These units must be installed in UL listed junction boxes.

2.These units must be installed with conduit in accordance with the National Electrical Code.

Wall Mounting Site Preparation

The remote control panel can be mounted in a wall-mountable four space mini-AAP A/V connector panel (such as a one-gang CPM101) and then set into a wall with either a standard stud-mounted wall box or with a wall mounting bracket (IN9181). The remote control panel can also be mounted to any wall-mountable Extron device that incorporates a four space A/V mini-AAP connector panel, such as a three-gang RGB 468 Mxi. See Mini-AAP mounting options in Appendix A, Reference Information, for a partial list of devices that can accept four space mini-AAPs.

Choose a location that allows cable runs without interference. Allow enough depth for the wall box and the cables. You should install the cables in the wall or furniture, with or without conduits, before installing the mounting bracket or wall box.

The installation must conform to national and local electrical codes and to the equipment’s size requirements.

2-2 CTP150CM Remote Control Panel • Installation and Operation CTP150CM Remote Control Panel • Installation and Operation 2-3