Magnavox 40MF430B owner manual Initial Setup, Make sure the unit is connected to antenna or cable

These operations are accessible by remote control.

Some may also be accessible by controls on the main unit.

Initial Setup

This section will guide you through the unit’s initial setting which includes selecting a language for your on-screen menu and autoprogram, which automatically scans and memorizes viewable channels.

Before you begin:

Make sure the unit is connected to antenna or cable.

1 After making all the necessary connections, pressto turn on the unit.

•It may take a few moments to turn on the unit for the first time.

•[Initial Setup] menu appears automatically after the unit is turned on.

2 Use ▲/▼ to select the on-screen language from the choices (English / Español / Français) on the right side of the TV screen.

3 Use ▲/▼ to select [Antenna] for TV channels or [Cable] for CATV channels, then press OK

Initial Setup

Make sure the antenna is connected to ''ANT. IN'' jack.		Antenna
Select your signal source.
		Cable
		Skip
Antenna	Or
Cable
	ANT.IN

Select OK OK BACK Back MENU Skip

[Autoprogram] will begin.

Initial Setup

Please wait while the system is scanning for channels. Auto programming may take more than 20 minutes to complete.

0%

Digital channels	0 ch
Analog channels
	0 ch

MENU Skip

									English
4		Select “Retail” or “Home” for your location.								INTRODUCTION
		Use ◄/► to select the desired location setting, then
		press OK.
		Initial Setup
										PREPARATION
				Select		OK OK
				Retail		Home
		Select [Retail] store, the unit will be set up with
		predefined setting for retail displays.								WATCHING
		to your preference.
		• Select	[Home], the unit is set to maximize the energy
		efficiency for home setting and it can be adjusted
		through a choice of picture and sound quality according
		• When the initial setup is completed, the lowest								TV
		memorized channel with the confirmation message of
		the location setting will be displayed on the TV screen.
										OPTIONAL
Note
•	If you are not receiving a signal from your cable service, contact the Cable
•	provider.									SETTING
	[Cable] only		once.When you change the connection (Antenna / Cable),
	If you press		or MENU during autoprogram, this setting will be canceled.
•	The initial autoprogram function can be executed for either [Antenna] or
	set [Autoprogram] again. ➠ p.19							Later
•		Try Autoprogram again?								TROUBLESHOOTING
	If there is no signal input from the antenna terminal and no operation for
	several seconds after you turn on the unit, [Helpful Hints] appears. Follow
	the instructions listed on the TV screen.
		Initial Setup
		No channel is registered.						Retry
		Verify that you have a cable connected to the "ANT. IN" jack on the back
		of the TV, the channel installation process searches this connection. If								INFORMATION
		you are using a cable or satellite box, please confirm the input which
		you have connected the box and press "SOURCE" key on the remote
		control to select the appropriate source input.
				Select	OK OK		MENU Skip

•You must set [Home] in step 4. Otherwise, the settings of picture and sound quality you adjusted will not be memorized after you turn off the unit.

After an initial setup is completed...

•If you want to scan the channels automatically again.

[Autoprogram] ➠ p.19

•You can add the desired cable and analog channels unmemorized by autoprogram.

[Add Channels] ➠ p.20

•If you want to change to another language.

[Language Selection] ➠ p.21

•If you want to change the location setting.

[Location] ➠ p.30

15

EN