Magnavox 26MF330B, 32MF330B Initial Setup, Make sure the unit is connected to antenna or cable

These operations are accessible by remote control.

Some may also be accessible by controls on the main unit.

Initial Setup

This section will guide you through the unit’s initial setting which includes selecting a language for your on-screen menu and autoprogram, which automatically scans and memorizes viewable channels.

Before you begin:

Make sure the unit is connected to antenna or cable.

1 After making all the necessary connections, pressto turn on the unit.

•It may take a few moments to turn on the unit for the first time.

•[Initial Setup] menu appears automatically after the unit is turned on.

2 Use ▲/▼ to select the on-screen language from the choices (English / Español / Français) on the right side of the TV screen.

3 Use ▲/▼ to select [Antenna] for TV channels or [Cable] for CATV channels, then press OK

Initial Setup

Make sure the antenna is connected to ''ANT. IN'' jack.		Antenna
Select your signal source.
		Cable
		Skip
Antenna	Or
Cable
	ANT.IN

Select OK OK BACK Back MENU Skip

•[Autoprogram] will begin.

Initial Setup

Please wait while the system is scanning for channels. Auto programming may take more than 20 minutes to complete.

0%

Digital channels	0 ch
Analog channels
	0 ch

MENU Skip

								English
4		Select “Retail” or “Home” for your location.							INTRODUCTION
		Use ◄/► to select the desired location setting, then
		press OK.
		Initial Setup
									PREPARATION
			Select		OK OK
			Retail		Home
		Select [Retail] store, the unit will be set up with
		predefined setting for retail displays. In this setting, the							WATCHING
		efficiency for home setting and it can be adjusted
		power consumption may possibly exceed the limited
		requirement of the ENERGY STAR® qualification.
		• Select [Home], the unit is set to maximize the energy
		through a choice of picture and sound quality according							TV
		to your preference.
		• When the initial setup is completed, the lowest
									OPTIONAL
		memorized channel with the confirmation message of
		the location setting will be displayed on the TV screen.
Note									SETTING
•	If you press or MENU during autoprogram, this setting will be canceled.
•	If you are not receiving a signal from your cable service, contact the Cable
	provider.
•
	The initial autoprogram function can be executed for either [Antenna] or
	[Cable] only once.When you change the connection (Antenna / Cable),								TROUBLESHOOTING
•	set [Autoprogram] again. ➠ p.19
	If there is no signal input from the antenna terminal and no operation for
	several seconds after you turn on the unit, [Helpful Hints] appears. Follow
	the instructions listed on the TV screen.
		Initial Setup
		No channel is registered.					Retry
							Later
		Try Autoprogram again?							INFORMATION
		Verify that you have a cable connected to the "ANT. IN" jack on the back
		of the TV, the channel installation process searches this connection. If
		you are using a cable or satellite box, please confirm the input which
		you have connected the box and press "SOURCE" key on the remote
		control to select the appropriate source input.
			Select	OK OK		MENU Skip

•You must set [Home] in step 4. Otherwise, the settings of picture and sound quality you adjusted will not be memorized after you turn off the unit.

After an initial setup is completed...

•If you want to scan the channels automatically again.

[Autoprogram] ➠ p.19

•You can add the desired cable and analog channels unmemorized by autoprogram.

[Add Channels] ➠ p.20

•If you want to change to another language.

[Language Selection] ➠ p.21

•If you want to change the location setting.

[Location] ➠ p.30

15

EN