Magnavox 19ME601B, 22ME601B owner manual TV Speakers, Primary MTS, Autoprogram, Ext Amp, Mono

TV Speakers

Select the audo output from the unit's speakers, or not. If your amplifier s HDMI link function compat hie and connected b7

an HDMI cable to this unit, some sound operations such as volume up can be changed b7 using ths unit's remote control.

Make sure [fun-Link Control] is set to [On]. n,=, p.22

Use	A/•	to select the		desired		option,	then	press		OK.
On		The	sound		wil	be output	flsm	the	unt's speakers.
Off		The	sound		wil	not be output		from	the unit's
		speakers.
		You can contro audio output flx_m your
Ext.	Amp	connected			HDMI nk devices			by usng		this unt's
		remote		control.

Primary MTS

You can set the output mode as a default for the sound mode

(NISC only).

This sett ngs not nterlocked when you change the output mode by pressing SAP [Sound Functions] n,=, p.13

Autoprogram

If you switch wires (e.g. between antenna and C/_l V) or f you move the unit to a d fferent area after the nitial sett ng, or f

you restore the D]V channels 7ou deleted, t s recommended

to use Autoprogram to perform a new channel search ....

1 Use &IV to select [Autoprogram],then press OK.

2 Use A/• to select an appropriate option, then press OK.

•When connected toVHF/UHF antenna, select [Antenna].

•When connected to C/X[V, select [Cable].

•[Autoprogram] will begin.

Use A/• to select the desh'ed option, then press OK.

st....	I Outputs	mol,o	Judw.
Mono
SAP	I Outputs	_d	_ud o program.

tup

Before you begin:

Make sure the unt is connected to antenna or cable.

1Use &/• to select the item you want to adjus%then press OK,

Autoprogram

• When the scanning and memorzing are completed.the ;i

lowest memorized channel will be d splayed.

Noe

After sett n£ [Autoprogram], using CH+/- on the remote contro skips unavailable pro%ares automat ca y.

If you are, not receiv n£ a sgnal flsm your cable serv ce, contact the Cabe prov dens

If you pless _ or MENU durng autoplsgram, the setup of TV channels w be car, teed.

Even f [Autoprogram] s competed, the ch nne} st,ICing w be oat fthe AC power cord s unplu%ed before the unit goes nto

star'dby mode	by	press n£ _.
The PIN code	will	be requ	red	once you set a PIN code n the
[Child Loci<].	,,,.	p.20
If you want to	change your		PIN	code, foow the nstruction of
[Change PIN].	,,,f, p.21

2 Adjustthe following items.