Basic Cable TV Connection
The Cable TV signal into your home may be a single cable (75 ohm) or may include a Cable
Box. In either case, the connection to the TV is easy.
If your Cable TV signal comes directly via a 75Ω coaxial cable, use the following steps.
1 Connect the Cable TV signal to the
75 OHM ANTENNA INPUT jack on the rear of the TV. Screw it down tight.
2 Plug the TV’s power cord into a power outlet and turn on the TV. Set TV/CABLE to CABLE as detailed on page 11.
Refer to AUTO PROGRAM to set up your available TV channels. Details are on page 12.
If you have a Cable Box, use the following steps.
1 Connect the Cable TV signal to the IN jack on the Cable Box.
2 Connect a separate coaxial cable to the OUT jack on the Cable Box and to the 75 OHM ANTENNA INPUT jack on the rear of the TV.
3 Plug the TV’s power cord into a power outlet and turn on the TV. Set TV/CABLE to CABLE as detailed on page 11.
1
Cable TV Company
75 OHM
ANTENNA
INPUT
4 Set the TV to channel 3 or 4 (the same as the Channel 3/4 switch on your Cable Box if applicable). Change chan- nels at the Cable Box.
Cable TV Company
Cable Box
75OHM
ANTENNA
INPUT
Helpful Hints
An RF coaxial cable (to con- nect the Cable Box to the TV) may be supplied by the Cable TV company. It is not supplied with the TV.
You can connect a Satellite Receiver the same way you would connect a Cable Box.
Your Cable Box may have separate Audio and Video Out jacks instead. If so, use audio and video cables to connect the AUDIO/VIDEO OUT jacks of the Cable Box to the AUDIO/VIDEO IN 2 jacks on the rear of the TV.
Press TV/AV/EXIT on the TV’s remote control to set the TV to the VIDEO 2 channel. Change TV channels at the Cable Box.
5