Gefen EXT-DVIRS232-1FO user manual DIP 2 Deep Color, DIP 3 Calibration Mode

Page 13

DIP SWITCH CONFIGURATION

DIP 2 - Deep Color

NOTE: DIP switch 2 is only functional when DIP switch 1 is set to the OFF position.

•OFF - Enables Deep Color support (12-bit color)

Enables Deep Color support. In Pass-through EDID Mode, setting DIP 2 to the OFF position has no effect since all EDID information is passed through.

•ON - Forces 8-bit Color

Disables Deep Color in the EDID. Deep Color management is only available when Local EDID is being used.

DIP 3 - Calibration Mode

•OFF - Enables Calibration Mode

Enables Calibration Mode. Make sure to set DIP switch 3 on both the

Sender unit and Receiver unit when calibrating the Extenders. See page 12 for details.

•ON - Calibration Mode Lock

Locks the calibration settings. Set DIP switch 3 on both the Sender unit and Receiver unit to the ON position after the calibration process has completed. See page 12 for details on the calibration process.

10

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Extender for DVI and RS232 Over One Fiber Optic Cable Technical Support Asking for AssistanceTechnical Support Hours Write ToContents Gefen IntroductionGefen Extender for DVI and RS232 Over One Fiber Optic Cable How It WorksOperation Notes Features FeaturesPackage Includes Sender Unit Layout Sender Unit Descriptions Power IndicatorReceiver Unit Layout Receiver Unit Descriptions Fiber Optic Connector SC-TypeEXT-DVIRS232-1FO DIP Switches DIP Switch ConfigurationSender unit DIP 1 Edid Mode DIP 2 Deep Color DIP 3 Calibration ModeDIP 2 Not Used Receiver unit DIP 1 Not UsedTroubleshooting Calibration ProcedureCalibrating the Sender unit and Receiver unit 3 2 3 4 RS-232 Serial Control5V DC SpecificationsProduct Registration WarrantyRev A2 Nordhoff St., Chatsworth CA
Top Page Image Contents