Gefen EXT-DVIRS232-1FO user manual Sender Unit Descriptions, Power Indicator

Page 8

SENDER UNIT DESCRIPTIONS

1P (Power Indicator)

This two-color LED will turn bright red once the included 5V DC locking power supply has been properly connected to the unit and the locking power supply has been connected to an available wall outlet. This LED will turn bright green once the Sender unit and Receiver unit are communicating correctly.

2C (Calibration Indicator)

This LED will alternate from red to green during the calibration procedure. The LED will turn solid green once the calibration procedure has been completed. See page 12 for more information on the calibration procedure.

3DVI In

Connect a computer or other DVI source to this DVI port.

4RS-232

Connect an RS-232 cable from this port to the controlling device.

5Fiber

This connector accepts a single strand of SC-terminated fiber optic cable that will link the Sender unit and Receiver unit together. The Gefen Extender for DVI and RS232 Over One Fiber Optic Cable will only accept multi-mode fiber optic cables.

65V DC

Connect the included 5V DC Locking Power Supply to this receptacle.

5

Image 8
Contents Extender for DVI and RS232 Over One Fiber Optic Cable Asking for Assistance Technical SupportTechnical Support Hours Write ToContents Introduction GefenGefen Extender for DVI and RS232 Over One Fiber Optic Cable How It WorksOperation Notes Package Includes FeaturesFeatures Sender Unit Layout Power Indicator Sender Unit DescriptionsReceiver Unit Layout Fiber Optic Connector SC-Type Receiver Unit DescriptionsEXT-DVIRS232-1FO Sender unit DIP 1 Edid Mode DIP Switch ConfigurationDIP Switches DIP 3 Calibration Mode DIP 2 Deep ColorReceiver unit DIP 1 Not Used DIP 2 Not UsedCalibrating the Sender unit and Receiver unit Calibration ProcedureTroubleshooting RS-232 Serial Control 3 2 3 4Specifications 5V DCWarranty Product RegistrationRev A2 Nordhoff St., Chatsworth CA