Timed On, Panel is Off | Monster Cable HTPS 7000 MKII manual

TROUBLESHOOTING

	Symptom		Possible Cause		Remedy
	Symptom		Possible Cause		Remedy

	“Timed On”		You are using the Remote Turn-On feature		• Plug the plug into component you wish
	indicator on front		(Same as Switched) and haven’t plugged		to use to activate the Remote Turn-On.
	panel is Off.		the plug into the component you wish to use
			to activate the Remote Turn-On.

			The component remote control you are using		• Replace the battery powering
			to power the Remote turn-on has a dead battery.		the component remote control.

			The component you wish to use to activate the		• Plug the component into a properly
			Remote Turn-On isn’t plugged into a properly		grounded 120 volt (nominal) outlet.
			grounded 120 volt (nominal) outlet.

	Video picture		The incoming video signal is not properly		• Contact your cable or satellite provider
	has rolling bars		grounded.		to correct your installation.
	or ghosting.

	The PowerSource		The PowerSource protection circuitry has		• The PowerSource must be replaced.
	is emitting a loud		sacrificed itself to protect connected equipment		See the Warranty Information section
	buzzing alarm.		from a catastrophic surge.		for important details.

25

Image 30

Monster Cable HTPS 7000 MKII owner manual Timed On, Indicator on front Same as Switched and haven’t plugged, Panel is Off

Contents

Signature Htps 7000 Mkii Table of Contents Important Safety Information Page Proper Grounding and Installation Important Note Proper Power and Protection Dear Enthusiast Noel Lee Head Monster MONSTER’S Exclusive T2 Technology Or above 132Vrms MONSTER’S Patented Clean Power Stages Minds Behind the Monster Powersource Design Monster Signature Htps 7000 Mkii Powersource Features 3IGNATURE /*-ÇäääÊ Rear Signature Htps 7000 Mkii Powersource Features Page HOOK-UP Guide Digital Outlet Hook-UpDigital Outlets Video Outlet Hook-Up Video Outlets Analog Audio Outlet Hook-Up Analog Audio OutletsUse a corresponding outlet for best performance Ultra-High Current Audio Outlet Hook-Up High Current Audio Outlets Outlet Programming Or when triggered by an external signal Over-Voltage and Under-Voltage Audible Alarm Setting Over-Voltage and Under-Voltage Automatic Shutdown Setting Coaxial Connections Hook-Up Phone/Network Connections Hook-Up Protect Phone/Network Line Connections as Follows Remote DC In Control Hook-Up Remote AC In Control Hook-Up Remote DC Out Control Hook-Up To Control Components Troubleshooting Symptom Possible Cause Remedy Turn the component power On Turn the PowerSource OnUnswitched outlet Grounded, attach a copper wire Plug the plug into the component Unswitched LEDSwitched LED is Off You wish to use to activate Panel is Off Indicator on front Same as Switched and haven’t pluggedTimed On Is emitting a loud Signature Htps 7000 Mkii Powersource Page Page Manual de l’utilisateur Table DES Matières Mise EN Garde Mise à la terre et polarisation Importantes Informations DE SécuritéMise EN Garde Sources d’alimentation Mise EN Garde Liquides Éviter les chocs électriques Mise EN Garde Sécurité du cordon d’alimentation Mise EN Garde Précautions en cas d’orage Mise À LA Terre ET Installation Adéquates Mise EN Garde Mise à la terre adéquateRemarque importante Protection et alimentation adéquates Cher passionné Direction de Monster Technologie T2 Exclusive À Monster Étages Brevetés Clean Power DE Monster LES Cerveaux Derrière LE Concept Powersource DE Monster VUE Avant VUE Spécifications DU Powersource Signature Htps 7000 Mkii De vos appareils Guide DE Raccordement Raccordement aux prises numériquesPrises Numériques Raccordement aux prises vidéo Prises Vidéo Raccordement aux prises audio analogique Prises Audio Analogiques Raccordement aux prises audio de puissance Prises Audio de Puissance Programmation de sortie Guide DE Raccordement Réglage de l’alarme sonore de surtension et de sous-tension Guide DE Raccordement Raccordement aux connexions coaxiales Raccordement aux connexions téléphonique/réseau Protégez les connexions téléphonique/réseau comme suit Programmées s’allument après le délai imparti Vers les appareils de contrôle Dépannage Allumez l’appareil PowerSource est allumé Les haut-parleursUn appareil branché Émettent un Commutées est éteinte Des prises à distance sans avoir La DEL de la prise nonCommutée est éteinte Distance est trop faible Votre installation PowerSource dans l’appareilLe PowerSource Branchez la prise électrique du 30V c.c 15A/1800W Phase-Neutre P-NPhase-Terre P-T Neutre-Terre N-T 12V c.c mA