
Memory Upgrade
Module
Your Fujitsu LifeBook notebook comes with 128MB or 256MB high speed Synchronous Dynamic RAM (SDRAM) factory installed. To increase your notebook’s memory capacity, you can replace the original memory module with a higher capacity module. The memory upgrade must be a
C A U T I O N S
■Do not remove any screws from the memory upgrade module compartment except the ones specifically shown in the directions for installing and removing the memory upgrade module.
■The memory upgrade module can be severely dam- aged by
INSTALLING A MEMORY UPGRADE MODULE
1.Turn off power to your LifeBook notebook using the power switch, and remove any power adapter
(AC or auto/airline).
2.Make sure that all the connector covers are closed.
3.Turn the notebook bottom side up, with the front panel toward you.
4.Remove the screws of the memory upgrade module compartment. (Figure
5.Remove the cover.
Figure 4-9 Opening the Memory Upgrade Compartment
6.Remove the memory upgrade module from the static guarded sleeve.
7.Align the memory upgrade module with the part side up. Align the connector edge of the memory upgrade module with the connector slot in the compartment. The connector will be pointing toward the rear of the notebook.
U s e r I n s t a l l a b l e F e a t u r e s
8.Insert the memory upgrade module at a 45° angle. Press the connector edge of the module firmly down and into the connector until it lodges under the retaining clip. You will hear a click when it is prop- erly in place. (Figure
Figure 4-10 Installing a Memory Upgrade Module
9.Replace the cover.
10. Replace the screws.
P O I N T
The memory upgrade module is not something you routinely remove from your notebook. Once it is installed, you can leave it in place unless you want to change system memory capacity.
TO REMOVE A MEMORY UPGRADE MODULE
1.Perform steps 1 through 5 of Installing a Memory Upgrade Module.
2.Pull the clips sideways away from each side of the memory upgrade module at the same time.
3.While holding the clips out, remove the module from the slot by lifting it up and pulling towards the rear of your notebook. (Figure
Figure 4-11 Removing a Memory Upgrade Module
4.Store the memory upgrade module in a static guarded sleeve.
5.Replace the cover.
6.Replace the screws.
51