Bowers & Wilkins CT800 installation manual Table of Contents

Page 2

Table of Contents

Warranty	2
Owner’s Manual	3
Important Safety Instructions	3
Introduction	5
Environmental Information	5
The Concept	6
Planning the Installation	8
Checking the Contents	8
Speaker Position	8
Surround Speaker Dispersion Mode	9
Mounting the Speakers	10
Installing CT8 DS Into a Drywall	12
Installing CT8 DS to a Wall Surface	13
Connecting the System	15
The Speakers	15
The CT8 XO Crossover/Equaliser	16
Description of Controls	17
Conﬁgure the CT800 XO to the Speaker	19
Conﬁgure the Unit to the Gain of Each Ampliﬁer	19
Conﬁgure the Dipole Lobe for a CT8 DS	20
Conﬁgure the Equalisers	21
Running In and Ancillary Equipment	26
Aftercare	27
Speciﬁcations	28

1

Image 2

Contents CT800 Series Table of Contents How to claim repairs under warranty WarrantyLimited Warranty Important Safety Instructions Explanation of Graphical SymbolsPage Introduction Environmental InformationConcept Page Check the contents against Figure Planning the installation Planning the installationSafety Warning Speaker Position~60 o Mounting the speakers To take up any rocking. ﬁgure Installation into drywall ﬁgure Installation to wall surface ﬁgure Continue for all cases CT8 DS only Connecting the SystemSpeakers CT8 XO Rear Panel CT8 XO crossover/equaliser Description of Controls Description of controlsPage Conﬁgure the CT800 XO to the speaker Conﬁgure the unit to the gain of each power ampliﬁerEquipment Required Setting the Subwoofer gain Conﬁgure the dipole lobe for a CT8 DSTheory Conﬁgure the equalisersProcedure Page Our case the original measurement at position #10 is Rn Page Running In and Ancillary Equipment Ancillary equipmentAftercare Speciﬁcations CT8 LRCT8 DS