Vidikron VP-5000VHD Input Source, Aspect Ratio, Picture, Input Position, Calibration, Information

Page 48

Operation

	Composite							Gain
	S Video 1							Offset

	S Video 2						ISF Night - Display Color	Gamma
Input Source	Component SD							Color Temp.

	HD/RGB 1							AGC
	HD/RGB 1							AGC

	HD/RGB 2							Input Level

	HDMI 1							Brightness

	HDMI 2							Contrast

	16:9						ISF Night - Input Image	Color

Aspect Ratio	4:3							Tint

	Letterbox							Sharpness
	IntelliWide							Gain

	Cinema							Offset

	Brightness						ISF Night - Input Color	Chroma Delay

Picture	Contrast							Phase

	Color							Noise Filter
	Tint							Gain

	Sharpness							Offset
	Left/Right						ISF Day - Display Color	Gamma
							ISF Day - Display Color
Input Position	Up/Down							Color Temp.

	Width							AGC
	Height				Calibration			Input Level
					Calibration
	Overscan				(1080i analog and			Brightness
					(1080i analog and
	Recall ISF Night				lower-resolution sources)			Contrast
	Recall ISF Day						ISF Day - Input Image	Color
Memory Presets	Recall or Save Custom 1							Tint

	Recall or Save THX/Custom 2							Sharpness
	Recall or Save THX/Custom 2							Sharpness

	Reset Custom 1 and THX/Custom 2 to							Gain
	Factory Default
	Factory Default							Offset
	Serial Number
Information	Serial Number						ISF Day - Input Color	Chroma Delay
	Hardware
	Hardware							Phase
	Firmware
(read-only)	Firmware							Noise Filter
	Date
	Date						Save ISF Settings	Back / Confirm

								Left/Right

								Up/Down

							Output Shift	Width

								Height

								Save

								Owner Name

								ISF Calibrated
		Grey Bars 1					Splash Configure	ISF Other

		Grey Bars 2

	Test Video							Vidikron/ISF Logo Splash

		Color Bars 1
		Color Bars 1						Screen Timers
								Screen Timers
		Color Bars 2						(2 ... 60 sec.)

	Input Names	Rename, Restore or Save					OSD Position	Vert./Horiz., Normal/Wide,
								Height
	Remote Control	Primary
		Primary

		Secondary
		Secondary

				Left/Right, Up/Down, Width, Height
		Display Position
		Display Position		Pix By Pix
				(Enable/Disable; 1080i/p sources only)

				Brightness, Contrast, Color, Tint

	Display Device	Display Image		Sharpness, Color Temp.
		Display Image		AGC, Input Level
		(1080i digital or 1080p		AGC, Input Level

Service				Red Gain, Blue Gain, Green Gain
		sources only)		Red Gain, Blue Gain, Green Gain
		sources only)
				Red Offset, Blue Offset, Green Offset
				Red Offset, Blue Offset, Green Offset

				Gamma

		HD/RGB 1		Auto, RGB or YUV

	HD Format	HD/RGB 2
		HD/RGB 2

		ADC Bandwidth		Auto, 75 MHz, 150 MHz or 300 MHz
		ADC Bandwidth		Auto, 75 MHz, 150 MHz or 300 MHz

		YPbPr Input Resolution		Auto, 480i/p, 576i/p, 720p or 1080i

	Triggers	1 / 2 / 3 / Save

		Language		(currently, English only)

		Menu Mode

	Miscellaneous	Timeout

		Side Bar Color

		Film Mode (SD src. only)

	System Reset

	Restore Saved Settings

Figure 4-1. VHD Controller OSD Menu Structure for PlasmaView VHD

36	Vidikron PlasmaView VHD Installation/Operation Manual

Image 48

Contents

High Definition Plasma Displays Page Three Year Limited Warranty RIGHTS, Limits and Exclusions Product Information Retain for Your Records Important Safety Instructions Compliance Information Declaration of ConformityFCC Part 1Table of Contents Maintenance and Troubleshooting SpecificationsOperation Serial Communications1List of Figures List of Figures Xii 1Introduction About This ManualUsing This Manual If you need Turn toDescription, Features and Benefits Key Features and BenefitsOptional Accessories Models VP-5000VHD and VP-5000VHDa Optional Accessories Models VP-6500VHD and VP-6500VHDaOptional Accessories Models VP-103VHD 2Controls and Functions PlasmaView VHD at a GlanceDisplay Stand VP-5000VHD5 VP-103VHDVHD Controller Front Panel Slot 1 Not used Slot 2 Dual Hdmi inputVHD Controller Rear Panel InputsPower Input 100 to 240 VAC RS-232 Control PortVHD Controller Remote Control VHD Controller Remote ControlOn / OFF ENT EnterCursor Buttons Memory Preset Buttons ISF NT Night THX VP-6500VHD / Cust 2 all other modelsCust VideoControls and Functions 3Installation Remote ControlOperation Installation Quick Setup Step Procedure For Details, refer toInstallation Considerations High-Altitude OperationMounting the PlasmaView VHD on a Wall or TableVentilation Ventilation Requirements for Enclosure Mounting VP-103VHD Other Considerations Connections to the PlasmaView VHD and VHD Controller PlasmaView VHD Rear PanelSerial Connecting Source ControllerHdmi Connections See Figure Hdmi Source HD-DVD/BD/DVD Player or HD Tuner withDigital DTV RGB Connections See Figure Digital DTV RGB ConnectionsAnalog Computer RGB Connections See Figure Personal ComputerComposite/S-Video/Component Video Connections See Figure DVD Player, VCR Satellite Receiver Laser Disc etcConnection Outputs to ExternalEquipment Connecting an External IR Receiver to the VHD Controller 12. External IR Receiver Connection13. AC Power Connection 14. Cable Management Installation Turning on the Power 4OperationOperation Using the VHD Controller Menus Input Source Aspect RatioMemory Presets ServiceInput Source Aspect RatioMain Menu Input SourceAspect Ratio Description 169Hdtv programs in their native Aspect ratioPerform the adjustments in the order listed here PictureTypical Gray Bar Pattern for Adjusting Contrast Gray Yellow Cyan Green Magenta Red Blue Typical Test Pattern for Adjusting Sharpness Input PositionMemory Presets InformationCalibration ISF NightISF Day Operation Service Be used by ISF-certified technicians onlyDo not change the Type setting in this menu Calibration on HD/RGB 1 and HD/RGB 2 Color Space Select Auto, RGB or YUVOperation Operation 5Maintenance and Troubleshooting CleaningCleaning the Screen Cleaning the VentsTroubleshooting Tips Symptom Possible Causes SolutionTo Input Position on Maintenance and Troubleshooting Serial Command Syntax 6Serial CommunicationsCommand Value Description Min/max Stored?Brightness Command Parameter Value Description Min/max Stored? Miscellaneous Commands available on all inputs Hdinputres YESValue Stored? Description Enter key7Specifications Limited Warranty Specifications are subject to change without noticePower Requirements WeightPlasmaView VHD Dimensions 30.9 59.7 61.9 PlasmaView VHD Model VP-103VHD Dimensions with Floor Stand Resolution Supported TimingsRefresh Horizontal Pixel Frequency Supported? √ = Yes, = No MHz50.00 15.625 15.734/15.750Specifications Page 020-0781-01 Rev. a March

Related manuals

Manual 70 pages 272 b