Vidikron VL 52 operation manual Timer, Setup

Operation

Timer ➤

Timer

Time

On Timer

Off Timer

Sleep Timer

Setup ➤

Setup

OSD Language

PC Mode Adjust

Caption

Parental Control

Letterbox Mode

Input Selection

Monitor Out

Overscan

Input Label

HDMI Audio

RGB Signal

Film Mode

Auto Backlight

OSD Timer

Auto Off

HDMI CSC

Speaker: To disable the speakers, select Speaker from the Audio menu, set it to Off and press ENTER. The effect is similar to using the MUTE button, except that the DView “remembers” this setting if you turn off the display, then turn it back on.

Audio Delay: Use the Audio Delay control to correct audio/video synchronization issues that can occur with some types of source material. Select from 0 to 40 milliseconds of delay, as needed.

To set the DView’s internal clock or configure the on/off timers, select Timer from the Main Menu and press ENTER.

Time: To set the DView internal clock, select Time from the Timer menu and press ENTER. Then, use the up- or down-arrow button to select the hour of the day, AM/PM or the minute of the hour to set. Then, use the left- or right-arrow buttons to set that component of the time.

When finished, press MENU or EXIT.

On Timer: Use the On Timer to turn the DView on at a specific time of day. You can also specify a source input and volume level.

Off Timer: Use the Off Timer to turn the DView off at a specific time of day.

Sleep Timer: Use the Sleep Timer to turn off the DView after a specified interval.

To set the Sleep Timer:

•Select Sleep Timer from the Timer menu and press ENTER. Use the right- or left-arrow button to select 10, 30, 60, 120 or 180 minutes. Then, press MENU.

– OR –

•Press the TIMER OFF button on the remote control repeatedly to select the desired timer interval.

Use the controls in the Setup menu to perform advanced image quality adjustments and access various other DView features.

OSD Language: Select OSD Language from the Setup menu and press ENTER. Then, use the up- or down-arrow buttons to select the OSD language (English, French, Spanish, Portuguese or German). Press ENTER again to confirm your selection.

PC Mode Adjust: To improve the quality of displayed images from a computer or other VESA-compliant, RGB (480p or higher) source, select PC Mode Adjust and press ENTER.

•Auto Adjust: Auto Adjust automatically adjusts settings to optimize computer images. To execute Auto Adjust on command, select Auto Adjust and press ENTER.

Auto Adjust may take some time to complete, depending on the

Note characteristics of the incoming signal.

•Clock: Use the up- or down-arrow buttons ( , ) to highlight Clock. Then, use the right-arrow button ( ) to increase the pixel clock rate; use the left-arrow button ( ) to decrease it.

•Phase: Adjust the phase if the image shows shimmer or “horizontal noise.” Pixel phase adjusts the phase of the pixel sampling clock relative to the incoming signal. The effect of this control is similar to that of a tracking control on a VCR.

34 Vidikron VL-52 and VL-57 Installation/Operation Manual