ViewSonic VS12276-1G manual Antenna Installation Instructions, Outdoor Antenna Grounding

Page 5

Antenna Installation Instructions

1.Outdoor Antenna Grounding

If an outside antenna or cable system is connected to the product be sure the

antenna or cable system is grounded so as to provide some protection against

voltage surges and built-up static charges, Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the

mast and supporting structure, grounding of the lead-in wire to an antenna

discharge unit, connection to grounding electrodes, and requirements for the

grounding electrode.

2.Lightning

For added protection for this product during a lightning storm, or when it is left

unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the

product due to lightning and power-line surges. Do not disconnect the antenna or

the power cord during a heavy storm lighting may strike while you are holding the

cable cord, causing serious injury; turn off your LCD TV and wait for the weather to improve.

3.Power Lines

An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits, When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

Antenna

Ground clamp

Electric service equipment

Ground clamps

Antenna discharge unit

Grounding conductors

Power service grounding electrode system

ViewSonic

3

N2690w

Image 5
Contents Model No. VS12276-1G ViewSonic Contents Important Safety Instructions Product Registration Copyright InformationOutdoor Antenna Grounding Antenna Installation InstructionsCleaning the LCD TV Mounting ViewSonic LCD TV to the wall Package ContentsPlace the TV on a solid surface Connecting the powerPower Off Power OnLED Indicator Front of the Screen Introduction PowerVGA Signal Input / Audio Input Component signal Cr Pr, Cb Pb, Y InputAntenna Input AV/S-Video InputTips Headphone jackTo Use Remote Control Remote Control Battery Installation To Select Input Source To Use the OSD MenuPicture Setting Sound Setting Advance Settings(Not applicable for PC mode) TV Setting(Available only under TV mode) ViewSonic System Settings PC settings(under PC mode)Other Information Troubleshooting ViewSonic Declaration of RoHS Compliance Customer SupportEnglish Limited WarrantyViewSonic