ViewSonic VS12115-3M Notification, Safety, Installation, To Customers, Trademark Information

Page 7

ENGLISH

WARNING

Do not expose this TV to rain or moisture. It may increase the risk to fire or electronic shock.

Dangerous Voltage: The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence dangerous voltage within the inside of the product that may be sufficient level to constitute a risk of electric shock to persons.

Instruction: The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and servicing instructions in the literature accompanying the

appliance.

The TV shall not be exposed to dripping or splashing. Do not put objects filled with liquids, such as vases, on the TV.

CAUTION

To prevent electric shock, do not use this polarized AC plug with an extension cord, receptacle or other outlet unless the blades can be fully inserted to prevent blade exposure.

Declaration of Conformity

Trade Name: ViewSonic

Model: VT1930

Responsible Party: ViewSonic Corporation

Address: 381 Brea Canyon Road, Walnut, CA. 91789 USA

Telephone Number: 1-800-688-6688

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.

NOTIFICATION

This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the device and receiver.

Connect the device into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Pursuant to FCC regulations, be cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.

Safety

Operate the TV only on 120 – 240 V AC.

Use the AC power cord specified by

ViewSonic and suitable for the voltage where you use it.

The plug is designed, for safety purposes, to fit into the wall outlet only one way. If you are unable to insert the plug fully into the outlet, contact your dealer.

If any liquid or solid object should fall inside the cabinet, stop operating, unplug the TV immediately and have it check by qualified service technician.

If you will not be using the TV for a long time, disconnect the power by pulling the plug itself. Do not pull on the cord.

For details concerning safety precautions, refer to “Important Safety instructions” on page 3.

Installation

The TV should be installed near an easily accessible power outlet.

To prevent internal heat buildup, do not block the ventilation openings.

Do not install the TV in a hot or humid place, or in a place subject to excessive dust or mechanical vibration.

Avoid operating the TV at temperatures below 41°F (5°C).

When the TV is transported directly form a cold to a warm location, or if the room temperature changes suddenly, the picture may be blurred or show poor color due to moisture condensation. In this case, please wait a few hours before turning on the TV, in order to let the moisture evaporate first.

To ensure best picture quality, do not expose the screen to direct illumination or sunlight. We recommend you use spot lighting directed down from the ceiling or to cover the windows that face the screen with opaque curtains. It is better that TV is installed where the floor and walls are not of a reflective material.

To Customers

To install the specified TV, sufficient expertise is required. Make sure you subcontract the installation to ViewSonic dealer or licensed contractors and pay adequate attention to safety during the installation.

Note

T h i s t e l e v i s i o n i n c l u d e s a Q A M demodulator, which should allow you to receive unscrambled digital cable television programming via subscription service to a cable service provider. The type of programming and signal provided by your cable service provider will affect the availability of digital cable television programming in your area.

Trademark Information

Macintosh is a trademark of Apple Inc., registered in the U.S. and other countries. HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of Dolby Laboratories.

Blu-ray Disc is a trademark.

Adobe is a registered trademark or a trademark of Adobe Systems Incorporated in United States and/or other countries.

Contact ViewSonic service team at: http://www.ViewSonic.com or call our service team: United States 1-800-688-6688, Canada 1-866-463-4775

ViewSonic

2

VT1930

Image 7
Contents ViewSonicTM Customer Support Product RegistrationViewSonic Merida ViewSonic Wall-Mount WMK-10 Kit model ViewSonic TV Model NoVT1930 Contents Copyright Information To Customers SafetyInstallation NotificationUSE Important Safety InstructionsAntennas CleaningBatteries Ventilation Magnetic InfluenceSound Carrying the TVMoisture InstallationLCD Screen Volume AdjustmentEnergy Star Information Compliance InformationFCC Statement Following information is only for EU-member statesSubstance Proposed Maximum Actual Concentration Declaration of RoHS CompliancePackage Contents List of FeaturesDisconnecting the Stand Installing the LCD TVInstalling the Stand Mounting ViewSonic LCD TV to the wall Wall Mount Kit Specifications Vesa Front View of the Product Rear View of the Product Hdmi connection AV connectionVideo connection Component YPbPr connectionHD Cable Box/HD Satellite Box Connecting the LCD TVCable System or VHF/UHF Antenna System Cable System and VHF/UHF Antenna SystemYPbPr or Component Connection DVI ConnectionPersonal Computer PC Timing Reference ChartOther Equipment Button Description Remote Control and TV ControlsInserting Remote Control Batteries Remote Control and TV ControlsButtons Number18 C.C ZoomChanging Channels Adjusting the VolumeOperation Turning the TV On and OffViewing the Menus Storing Channels into MemorySelecting the Input Source Favorite Channel SettingAdding/Erasing Channel Channel Name SettingAdjusting the Settings Closed Caption Setting Setting up Time menuUsing the Parent Controls ALL All types content Using the TV Features To Block Unrated Movie or TV Programs To Change PasswordTo Set Rating Region Table To block by Input Source To Restore Factory SettingUsing PC Function Programming your Cable or Satellite Box remote Cleaning the LCD TVDisclaimer Problem Possible Solution TroubleshootingRemote control unit does LCD SpecificationsViewsonictm LCD TV Limited WarrantyMexico Limited Warranty ViewSonicTM