OPERATING INSTRUCTIONS
Indicator lamp
Main power switch
POWER OFF |
| |
button |
| |
POWER ON | POWER ON/OFF | |
button | ||
button | ||
| ||
| VOL | |
| RGB 1 RGB 2 MUTE VOL |
AV1 AV2 AV3 AV4
AUTO PinP SIZE RECALL
MENU
OK
ID | ID SET |
Turning Power On and Off
•To turn the monitor power ON, press the main power switch on the back of the unit to ON, and then press the SUB POWER button or the ON/OFF or ON button on the remote control.
•To turn the monitor power OFF, press the SUB POWER, or the ON/OFF, or OFF button on the remote
control, and then press the main power switch to OFF.
•During normal use, the main power switch is set in the ON position, and the monitor can then be turned ON/OFF using the SUB POWER button or the ON/OFF button on the remote control.
Indicator lamp
Indicator | Power status | Operating | |
lamp | |||
|
| ||
|
|
| |
Off | Off | When the main power switch is set | |
to OFF. | |||
|
| ||
|
|
| |
Red | Off | When the main power switch is | |
ON, and SUB POWER is OFF. | |||
(standby) | |||
|
| ||
|
|
| |
Green | On | When the main power switch is | |
ON, and SUB POWER is ON. | |||
|
| ||
|
|
| |
| Off | When the main power switch is | |
Orange | ON, and SUB POWER is ON. The | ||
(Power Save) | |||
| unit is in Power Save mode. | ||
|
| ||
|
|
|
When the indicating lamp lights orange or the message “No Sync. Signal”, “Power Save” or “Invalid Scan Freq.” appears on the screen, there is something unusual about the status of reception.
See “Power Save Mode” or “Symptoms That Seemingly Appear to be Failures.” 
ATTENTION
•Avoid repeatedly turning the monitor on and off at short time intervals. Failures might result from such operation.
•Turn off the main power switch before leaving the monitor out of use for an extended period of time.
•If a power failure occurs while the main unit is running, it will
be powered on upon recovery from the failure. Turn off the unit's main power switch to avoid power surges upon recovery.
ViewSonic VPW4255 16