General Operation

•ON/OFF

Switch on the unit by pressing POWER button (1). When system is on, press it again to turn it off.

•FACEPLATE RELEASE

Press REL button (2) to draw out the faceplate, push the panel to draw in.

When the faceplate is drawn out, turn the faceplate upward and adjust TV display.

•SELECTING SOUND MODE

Press SEL button (6) to move display through volume, bass, treble, balance and fader functions. Use VOLUME > (7) and VOLUME < (8) buttons to adjust the selected mode. When mode has not been adjusted for several seconds, display returns to previous display status (e.g. radio display or CDC display).

VOL	BAS	TRE	BAL	FAD
(Volume)	(Bass)	(Treble)	(Balance)	(Fader)

Volume

Adjust volume level using VOLUME > (7) and VOLUME < (8) buttons.

Bass

Press SEL button (6) for one time. Adjust bass level using VOLUME > (7) and VOLUME < (8) buttons.

Treble

Press SEL button (6) for two times. Adjust treble level using VOLUME > (7) and VOLUME < (8) buttons.

Balance

Press SEL button (6) for three times. Adjust sound balance between left and right speakers using VOLUME > (7) and VOLUME < (8) buttons.

Fader

Press SEL button (6) for four times. Adjust sound balance between front and rear speakers using VOLUME > (7) and VOLUME < (8) buttons.

•SELECTING PLAYING MODE

When the screen display is drawn in, press MODE button (12) to select desired playing mode between radio and CDC. When the screen display is drawn out, the unit would automatically switch into TV mode. By pressing MODE button (12), you can select desired playing mode among TV, radio and CDC.

CAUTION: The unit cannot be switched into TV mode, when the car is running. So at this time, you just select playing mode between radio and CDC.

•MUTE

Press MUT button (3) to cut down sound output, “MUTE” will appear on the display. Press it again to resume the previous volume mode.

•LOUDNESS

Press LOU button (22) to increase bass output, “LOUD” will appear on the display. Press it again to release the mode.